Draper CDH120V, CDH140V manual Getting to Know Your Cordless DRILL/CHARGER, Fig.B

GETTING TO KNOW YOUR

CORDLESS DRILL/CHARGER

	✴✌	✮✌
✬✌		✱✌	✭✌
		✫✌
		✪✌
✲✌
✳✌
			✯✌
		✰✌	FIG.B

✪✌ TRIGGER - When the variable speed switch trigger is depressed the chuck will rotate (providing the direction switch is in a clockwise or anticlockwise position).

✫✌ FORWARD/REVERSE LEVER - This lever determines the direction of rotation of the chuck, i.e. clockwise or anticlockwise.

✬✌ KEYLESS CHUCK - This is for holding tools, i.e. drill bits or screwdriver bits. ✭✌ RATING PLATE - Shows Part No., voltage, capacity, etc.

✮✌ TWO-SPEED GEARBOX SELECTOR SWITCH - This adjusts the rotation speed range of the chuck via the two-speed gearbox. (NOTE: Only change gear when the drill has completely stopped).

✯✌ BATTERY RELEASE - To release the battery pack, squeeze the grips located on either side of the battery casing and carefully slide it out.

✰✌ BATTERY PACK - This is the drill’s power supply.

✱✌ TORQUE CONTROL - There are 11 torque settings, settings 1-10 are normally used for hammer action. The eleventh setting is for standard drilling.

✲✌ BATTERY CHARGER - Charges the battery in approximately 1 hour. ✳✌ CHARGING INDICATOR - This will glow when the battery is charging.

✴✌ HAMMER SETTING - Select this setting for hammer drilling into brickwork/masonry.

- 7 -