Draper CDH140V, CDH120V manual Operation and USE, Battery Charging

OPERATION AND USE

BATTERY CHARGING

To charge the battery pack it must first be removed from the drill. To release the battery pack squeeze the grips located on either side of the battery casing and gently pull the battery pack from the housing (fig.1).

Plug the battery charger unit into a 13 amp, three-pin socket. Place the battery in the charger as shown in (fig.2). Making sure the + and - on the battery line up with the + and - on the charger (+ T0 +, - T0 -). Do not force. Ensure the battery is inserted correctly. The indicator light on the charger will now glow to show that the battery is charging (fig.3). When the battery is fully charged the light will go out (approx. 1 hour). The battery pack can then be removed and used to power the tool. To refit the battery pack to the drill push firmly until the battery pack locates and snaps into place.

NOTE: The battery was discharged after manufacturing and will therefore require five to ten charges/discharges before it reaches its full capacity.

INSTALLING AND REMOVING BITS

This drill is fitted with a keyless chuck, this means that a chuck key is not required to secure the drill or screwdriver bit. Place the drill or screwdriver bit into the chuck as far as it will go, then hand tighten. Short screwdriver bits need only be inserted to the depth of the hexagon shank before tightening the chuck by hand. Alternatively grip part ✪✌ of the chuck, (fig.4) and slowly run the drill clockwise until the chuck grips the bit, then hand tighten.

DIRECTION SWITCH

This switch determines the direction of rotation of the chuck, i.e. clockwise or anticlockwise.

To alter the direction of rotation stop the drill and push ✮✌, (fig.5), switch to the left or right. When the direction switch is in the 'F’ (forward) position the chuck will rotate clockwise when viewed from the handle end of the drill. When the switch is in the ‘R’ (reverse) position the chuck will rotate anticlockwise when viewed from the handle. Before operation check that the switch is set in the required position. Do not change the direction of rotation until the chuck comes to a complete stop.

When the drill is not in use move the direction switch to the neutral position (the middle setting).

- 8 -

Fig.1.

Fig.2.

Fig.3.

Fig.4.

✪✌

Fig.5.

✮✌