OPERATION AND USE
DRILLING WOOD AND PLASTIC
To prevent splitting around the drill holes on the reverse side, place a piece of scrap timber under the material to be drilled.
DRILLING MASONRY
Start drilling at a low speed to prevent the drill bit from wandering. Once penetration is achieved fully depress the trigger to achieve maximum speed and hammer power.
DRILLING METAL
Metals such as sheet steel, aluminium and brass may be drilled. Mark the point to be drilled with a punch or nail to help the drill bit tip to locate.
SCREWDRIVING
To prevent slip or damage to the screwhead, match the screwdriver bit to the screw- head size. To remove screws move the direction switch to the reversing position and apply pressure to the screwhead and depress the trigger slowly.
MAINTENANCE
Neither the drill or charger require any special maintenance.
Keep both the drill and the charger in a dry place where they will not be exposed to frost or direct sunlight.
BATTERIES
STOCK Nos: | PART Nos: | VOLTAGES |
54452 | CB12 | 12V |
54453 | CB14 | 14.4V |
IMPORTANT: Please note all repairs/adjustments should be carried out by a qualified person.
DRAPER HELPLINE: (023) 8049 4344
- 10 -