Instructions for use

E N G L I S H

We recommend to use professional accessories only.

•Clean and grease the bit shank.

•Insert the bit shank into the tool holder (6).

•Push the bit down and turn it slightly until it fits into the slots.

•Pull on the bit to check if it is properly locked. The hammering function requires the bit to be able to move axially several centimetres when locked in the tool holder.

•To remove a bit pull back the tool holder locking sleeve (12) and pull out the bit.

Fitting the side handle (fig. D)

The side handle (10) can be fitted to suit both RH- and LH-users.

Always use the tool with the side handle properly assembled.

•Loosen the side handle.

•For RH-users, slide the side handle clamp over the collar behind the tool holder, handle at the left.

•For LH-users, slide the side handle clamp over the collar behind the tool holder, handle at the right.

•Rotate the side handle to the desired position and tighten the handle.

Setting the drilling depth (fig. E)

•Insert the required drill bit as described above.

•Press the depth stop clamp (11) and keep it depressed.

•Fit the depth adjustment rod (9) through the hole in the depth stop clamp.

•Adjust the drilling depth as shown.

•Release the depth stop clamp.

Forward/reverse slider (fig. F1 & F2)

D25112(K)/D25113K/D25114K (fig. F1)

•Push the forward/reverse slider (3) to the RH-side for forward (RH) rotation. See arrows on tool.

•Push the forward/reverse slider (3) to the LH-side for reverse (LH) rotation.

D25213K (fig. F2)

•Push the forward/reverse slider (3) to the LH-side for forward (RH) rotation. See arrows on tool.

•Push the forward/reverse slider (3) to the RH-side for reverse (LH) rotation.

Always wait until the motor has come to a complete standstill before changing the direction of rotation.

D25112(K)/D25113K/D25213K -

Fitting the chuck adapter & chuck

•Screw the chuck onto the threaded end of the chuck adapter.

•Insert the connected chuck and adapter in the tool as though it were a standard SDS-plus®bit.

•To remove the chuck, proceed as for removing a standard SDS-plus®bit.

Never use standard chucks in the hammer drilling mode.

D25114K - R eplacing the tool holder with the chuck (fig. G)

•Turn the locking collar (8) into the unlocking position and pull the tool holder (6) off.

•Push the chuck (13) onto the spindle and turn the locking collar into the locking position.

•To replace the chuck with the tool holder,

first remove the chuck the same way as the tool holder was removed. Then place the tool holder the same way as the chuck was placed.

Never use standard chucks in the hammer drilling mode.

R eplacing the dust cover (fig. C )

The dust cover (7) prevents dust ingress into the mechanism. Replace a worn dust cover immediately.

•Pull back the tool holder locking sleeve (12) and pull the dust cover (7) off.

•Fit the new dust cover.

•Release the tool holder locking sleeve.

•Always observe the safety instructions and applicable regulations.