ASSEMBLY
CAUTION:
•Always be sure that the tool is switched off and unplugged before carrying out any work on the tool.
Installing side grip (handle)
005804
CAUTION:
•Always be sure that the side grip is installed
securely before operation.
Screw the side grip securely on the position of the tool as shown in the figure.
Installing or removing wheel guard (For depressed center wheel , multi disc / abrasive
For tool with locking screw type wheel guard
sure to tighten the screw securely.
To remove wheel guard, follow the installation procedure in reverse.
Installing or removing depressed center grinding
1 | 1. | Lock nut | |
2. | Depressed | ||
| |||
2 |
| center grinding | |
3 |
| ||
3. Inner flange | |||
001070
Mount the inner flange onto the spindle. Fit the wheel/disc on the inner flange and screw the lock nut onto the spindle.
To tighten the lock nut, press the shaft lock firmly so that the spindle cannot revolve, then use the lock nut wrench and securely tighten clockwise.
1 | 1. Lock nut wrench | |
2. Shaft lock | ||
|
1
3
2
009055
1
3
2
009056
CAUTION:
1.Wheel guard
2.Screw
3.Bearing box
1.Wheel guard
2.Bearing box
3.Screw
2
005917
To remove the wheel, follow the installation procedure in reverse.
WARNING:
Only actuate the shaft lock when the spindle is not moving.
OPERATION
WARNING:
• | It should never be necessary to force the tool. The |
| weight of the tool applies adequate pressure. |
| Forcing and excessive pressure could cause |
| dangerous wheel breakage. |
• | ALWAYS replace wheel if tool is dropped while |
| grinding. |
• | NEVER bang or hit grinding disc or wheel onto |
•The wheel guard must be fitted on the tool so that
the closed side of the guard always points toward the operator.
Mount the wheel guard with the protrusion on the wheel guard band aligned with the notch on the bearing box. Then rotate the wheel guard around 180 degrees. Be
| work. |
• | Avoid bouncing and snagging the wheel, especially |
| when working corners, sharp edges etc. This can |
| cause loss of control and kickback. |
• | NEVER use tool with wood cutting blades and other |
| sawblades. Such blades when used on a grinder |
7