24.Do not touch the workpiece immediately after operation; it may be extremely hot and could burn your skin.
25.Always be sure that the tool is switched off and unplugged or that the battery cartridge is removed before carrying out any work on the tool.
26.Observe the instructions of the manufacturer for correct mounting and use of wheels. Handle and store wheels with care.
27.Do not use separate reducing bushings or adaptors to adapt large hole abrasive wheels.
28.Use only flanges specified for this tool.
29.For tools intended to be fitted with threaded hole wheel, ensure that the thread in the wheel is long enough to accept the spindle length.
30.Check that the workpiece is properly supported.
31.Pay attention that the wheel continues to rotate after the tool is switched off.
32.If working place is extremely hot and humid, or badly polluted by conductive dust, use a
33.Do not use the tool on any materials containing asbestos.
34.Do not use water or grinding lubricant.
35.Ensure that ventilation openings are kept clear when working in dusty conditions. If it should become necessary to clear dust, first disconnect the tool from the mains supply ( use non metallic objects ) and avoid damaging internal parts.
36.When use
37.Cutting discs must not be subjected to any lateral pressure.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury.
FUNCTIONAL DESCRIPTION
CAUTION:
•Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool.
Shaft lock
1. Shaft lock
1
005802
CAUTION:
•Never actuate the shaft lock when the spindle is
moving. The tool may be damaged.
Press the shaft lock to prevent spindle rotation when installing or removing accessories.
Switch action
1 | 1. Switch lever |
|
005803
CAUTION:
•Before plugging in the tool, always check to see that the slide switch actuates properly and returns
to the "OFF" position when the rear of the slide switch is depressed.
To start the tool, slide the slide switch toward the "I (ON)" position. For continuous operation, press the front of the slide switch to lock it.
To stop the tool, press the rear of the slide switch, then slide it toward the "O (OFF)" position.
6