Grinding and sanding operation

frequently kick and cause loss of control leading to personal injury.

CAUTION:

Operation with abrasive cut-off / diamond wheel (optional accessory)

•After operation, always switch off the tool and wait until the wheel has come to a complete stop before putting the tool down.

ALWAYS hold the tool firmly with one hand on housing and the other on the side handle. Turn the tool on and then apply the wheel or disc to the workpiece.

In general, keep the edge of the wheel or disc at an angle of about 15 degrees to the workpiece surface.

010855

1.Lock nut

2.Abrasive cut-off wheel/diamond wheel

3.Inner flange

4.Wheel guard for abrasive cut-off wheel/diamond wheel

During the break-in period with a new wheel, do not work the grinder in the B direction or it will cut into the workpiece. Once the edge of the wheel has been rounded off by use, the wheel may be worked in both A and B direction.

	15
A	B
005831

The direction for mounting the lock nut and the inner flange varies by wheel thickness. Refer to the table below.