Installation, Mounting Instructions

Installation

MOUNTING INSTRUCTIONS

To mount the power supply directly to a wallboard, wall, or concrete refer to Figure 1 through 3 and do the following:

1.Remove the retaining screw from the door latch of the WCS1-4 power supply.

2.Open the door of the WCS1-4 power supply, and then remove the plug(s) from the required conduit hole(s) located on the bottom of the unit. Install 3/4-inch (1.91 cm) conduit fitting(s) (not supplied). Close the lid to the power supply.

3.Determine the mounting location for the WCS1-4.

4.Use the WCS1-4 power supply as a template and mark the four fastener positions on the mounting surface.

5.Prepare the holes for installation.

6.Attach the WCS1-4 power supply securely to the mounting surface with four fasteners of appropriate length. Fasteners between 1/4-inch and 5/16-inch diameter (not supplied) can be used.

MOUNTING HARDWARE WITH ANCHOR OR TOGGLE BOLT (NOT SUPPLIED)

DOOR

LATCH

RETAINING

SCREW

CONDUIT

FITTINGS

WALLBOARD

Mounting to Wallboard

Figure 1.

Mounting to Wallboard

WOOD SCREW (NOT SUPPLIED)

DOOR

LATCH

RETAINING

SCREW

CONDUIT

FITTINGS

WALL

Mounting to Wall

Figure 2.

Mounting to Wall

MOUNTING

HARDWARE (NOT SUPPLIED)

DOOR

LATCH

RETAINING

SCREW

CONDUIT

FITTINGS

CONCRETE WALL

Mounting to Concrete

Figure 3.

Mounting to Concrete

WARNING: Under light load conditions and high input power voltage, output voltage from the WCS1-4 power supply may reach 32 VAC. Pelco recommends that all equipment connected to the WCS1-4 power supply be rated to handle 32 VAC. Pelco’s Spectra® domes and Esprit® integrated positioning systems meet this requirement. Pelco cannot be liable for any damages resulting from incorrect wiring of the WCS1-4 power supply.

4	C561M-F (8/06)