Replacing the blade:Blades with chipped edges must be replaced and must not be reground because this causes the mower to be out of balance.
The blade must only be replaced by GARDENA Service or a specialist dealer authorised by GARDENA.
Only an original GARDENA blade must be used. GARDENA spares are available from your GARDENA dealer or via GARDENA Service.
•GARDENA replacement blade Art. 4091
A damaged or bent blade must be replaced because it will be out of balance.
Fault | Possible cause | Remedy |
Motor will not start | Power supply cable faulty. | vCheck power supply cable. |
|
|
|
| Extension cable may not have a | v Use extension cable with |
| large enough | |
|
| table (2. For your Safety). |
|
|
|
Motor jammed and making | Jammed with foreign body. | v Switch off motor, pull out |
a noise |
| mains plug and remove |
|
| foreign body. |
|
|
|
| Cutting height too low for the | v Raise cutting height or |
| lawn or mowing speed too high. | or reduce mowing speed. |
|
|
|
Loud noises, mower | Screws on motor, its fixing or on | v Have screws tightened by an |
rattling | the mower casing loose. | authorised specialist dealer |
|
| or |
|
|
|
Runs unevenly, mower | Blade damaged or blade | v Have blade tightened or |
vibrates strongly | mounting released from motor | replaced by an authorised |
| shaft. | specialist dealer or |
|
| |
|
|
|
| Out of balance because of | v Clean mower (see |
| very dirty blade. | 6. Maintenance). If this |
|
| does not rectify the fault, |
|
| contact GARDENA Service. |
|
|
|
Lawn is not cleanly cut | Blade blunt. | v Have blade replaced. |
|
|
|
| Cutting height too low. | v Increase cutting height. |
|
|
|
| Mowing speed too high. | v Reduce mowing speed. |
|
|
|
If any other faults occur, please contact GARDENA Service.
Please contact GARDENA Service before sending the mower. Repairs may only be carried out by GARDENA service centres or dealers authorised by GARDENA.
GB
17