ARM ARM DUI 0137A manual Select Configure Interface from the Options menu

Page 18

Connecting to RMHost

Note

If Load Image is disabled, you must stop the currently running application by selecting Stop from the Execute menu.

The image might stop at main() if the program contains this function. In this case, select Go from the Execute menu to continue from the breakpoint.

3.While your program is running, configure the interface as follows:

a.Select Configure Interface from the Options menu.

b.Select the General tab.

c.In the Target connection drop-down menu, select the option ATTACH:

Connect according to target properties, as shown in Figure 2-2.Click

OK.

Figure 2-2 Configure interface dialog box

4.Select the RealMonitor target as follows:

a.Select Configure Target from the Options menu. The Choose Target dialog box is displayed.

b.Select RealMonitor.dll as the target DLL, as shown in Figure 2-3 on page 25.

24

Copyright © 2000 ARM Limited. All rights reserved.. All rights reserved.

ARM DUI 0137A

Image 18
Contents ARM RMHost ARM RMHost User GuideUser Guide Chapter Debugging with RMHostContents Preface About this book onIntended audience Using this bookAbout this book Typographical conventionsFurther reading ARM publicationsOther publications Feedback Feedback on RMHostFeedback on this book ARM DUI 0137A Overview of RMHost About RMHost on RMHost requirements onAbout RMHost Application/RTOSOverview of RMHost RMHost requirements RMHost packageConnecting to RMHost Procedure for connecting to RMHost using AXD Debuggers chapter of the Multi-ICE User Guide Select Configure Interface from the Options menu Configure interface dialog boxDescribes how to do this RealMonitor Configuration dialog box Jtag controller search dialog box Deselect the the option Fetch module information from target Cancel No pc write access messageNo pc read access message AXD connection messages Lines 2212 Debugging with RMHost Debugging with RMHost Nonstop debugBackground memory access CPU register access Nonstop startupProfiling Data messagingSemihosting Debugging with RMHost Error messages RDITarget does not include an ARM processor Memory map forbids reading from location RMHost could not load the specified Jtag controller Other messages from RMHost Yes312 Using RMHost with Trace Debug Tools AsicConfiguring AXD to enable tracing with RMHost Performance of RMHost with TDTSelect Debugger Internals from the System Views menu Index RmoptsdminfoRmoptdatalogging Rmoptgetpc