ARM ARM DUI 0137A manual RMHost could not load the specified Jtag controller

Page 36

Debugging with RMHost

RMHost could not load the specified JTAG controller

This is displayed when the JTAG controller DLL could not be loaded.

RMHost internal error

Indicates some consistency failure inside the RMHost controller. You must report this error to your supplier, along with a description of the events leading up to the error.

RMHost protocol error (internal error)

The RMHost controller detected that it was about to violate the RealMonitor protocol, and aborted the operation. This must be treated in the same way as an internal error, and must be reported to your supplier.

RMTarget does not support an expected feature

The RMHost controller sent a command to the monitor that was not understood. This typically indicates an error in the RMTarget build, because the controller checks that a command is supported before using it.

RMTarget entered panic state (debug event while stopped)

The monitor detected a debug event (such as a breakpoint) while it was already stopped, and has gone into panic state. This should not occur during normal operation, and usually indicates a user error. For example, this might occur if you have set a breakpoint on some code that is used by an interrupt routine. The target must be reset.

RMTarget protocol error

The controller has detected a violation of the RealMonitor protocol by the target. This usually indicates a target fault, which can typically be resolved by resetting it.

RMTarget version does not match RMHost version

As part of initialization, the controller checks that the version number of the target matches its own version number. If they do not match, the controller cannot connect to the target. The version number is used in this way to protect against changes in the RealMonitor protocol between versions.

Unknown RMTarget error

RMTarget is reporting an error that is not understood by RMHost. See the description of the pointer to the error block in the ARM RMTarget Integration Guide.

310

Copyright © 2000 ARM Limited. All rights reserved.. All rights reserved.

ARM DUI 0137A

Image 36
Contents ARM RMHost ARM RMHost User GuideUser Guide Chapter Debugging with RMHostContents Preface About this book onUsing this book About this bookIntended audience Typographical conventionsFurther reading ARM publicationsOther publications Feedback Feedback on RMHostFeedback on this book ARM DUI 0137A Overview of RMHost About RMHost on RMHost requirements onAbout RMHost Application/RTOSOverview of RMHost RMHost requirements RMHost packageConnecting to RMHost Procedure for connecting to RMHost using AXD Debuggers chapter of the Multi-ICE User Guide Select Configure Interface from the Options menu Configure interface dialog boxDescribes how to do this RealMonitor Configuration dialog box Jtag controller search dialog box Deselect the the option Fetch module information from target Cancel No pc write access messageNo pc read access message AXD connection messages Lines 2212 Debugging with RMHost Debugging with RMHost Nonstop debugBackground memory access CPU register access Nonstop startupProfiling Data messagingSemihosting Debugging with RMHost Error messages RDITarget does not include an ARM processor Memory map forbids reading from location RMHost could not load the specified Jtag controller Other messages from RMHost Yes312 Using RMHost with Trace Debug Tools AsicConfiguring AXD to enable tracing with RMHost Performance of RMHost with TDTSelect Debugger Internals from the System Views menu Index RmoptsdminfoRmoptdatalogging Rmoptgetpc