HP 6 VoiceTab Plus Removal and replacement procedures, Tablet component replacement procedures

Page 19

5Removal and replacement procedures

Tablet component replacement procedures

CAUTION: Tablet components described in this chapter should only be accessed by an authorized service provider. Accessing these parts can damage the tablet and void the warranty.

This chapter provides removal and replacement procedures for authorized service provider only parts.

There are as many as 12 screws that must be removed, replaced, and/or loosened when servicing the tablet. Make special note of each screw size and location during removal and replacement.

Back cover

Description

Spare part number

 

 

Back cover

788634-001

 

 

Display panel assembly (6.0-in, (1280×720), LCD, 5-point capacitive TouchScreen, bonded, full

788637-001

lamination, OGS; includes display panel cable and TouchScreen cable)

 

 

 

Before disassembling the tablet, follow these steps:

1.Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and then shut it down through the operating system.

2.Disconnect the power from the tablet by unplugging the power cord from the tablet.

3.Disconnect all external devices from the tablet.

Remove the back cover:

CAUTION: Before turning the display panel assembly upside down, make sure the work surface is clear of tools, screws, and any other foreign objects. Failure to follow this caution can result in damage to the display panel assembly.

1.Place the tablet on a flat surface, display panel side down, with the power button toward you.

CAUTION: When inserting the plastic tool into the tablet as described in Step 2, make sure not to insert the tool into the volume control buttons area. Failure to follow this caution can result in damage to the tablet.

2.Use the finger notch (1) to release the bottom edge of the back cover (2) from the display panel assembly.

Tablet component replacement procedures 13

Image 19
Contents HP Slate 6 VoiceTab Plus Tablet Software terms Product noticeSafety warning notice Iv Safety warning notice Table of contents Power cord set requirements Product description Serviceability End user replaceable part Category Description Power requirementsOperating system External component identification Component Locating the product number and the serial number Illustrated parts catalogButton Actuators Kit , includes Tablet major componentsComponent Spare part number Back cover Middle frameScrew Kit Miscellaneous partsComponent Spare part number AC adapter HP headsetSpare part number Description Sequential part number listingService considerations Removal and replacement preliminary requirementsTools required Typical electrostatic voltage levels Relative humidity Event Grounding guidelinesPackaging and transporting guidelines Material Use Voltage protection level Equipment guidelinesDescription Spare part number Removal and replacement proceduresTablet component replacement procedures Back coverBattery Page Description Spare part number Middle frame 788635-001 Middle framePage Rear-facing webcam Middle frame see Middle frame on Antenna boardSpeaker and vibrator module System board Page Page Front-facing webcam Ambient light sensor board Page Specifications Country/region Accredited agency Applicable note number Power cord set requirementsRequirements for all countries Requirements for specific countries and regionsRequirements for specific countries and regions Recycling Jacks IndexTablet