5.Remove the Phillips PM1.4×3.6 screw (1) and the Phillips PM1.4×2.2 broad head screw (2) that secure the connector board to the display panel assembly.
6.Remove the connector board (3).
Reverse this procedure to install the connector board.
System board
Description | Spare part number |
System board equipped with an Intel Z2520
Equipped with a | |
|
|
Equipped with a | |
|
|
Before removing the system board, follow these steps:
1.Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and then shut it down through the operating system.
2.Disconnect the power from the tablet by unplugging the power cord from the tablet.
3.Disconnect all external devices from the tablet.
4.Remove the back cover (see Back cover on page 12).
22 Chapter 5 Removal and replacement procedures