HP 436853-001 manual Installation

Page 8

2.Shut down the operating system as outlined in the operation system instructions.

3.Power off the server and all the peripherals connected to it.

4.Unplug all cables from the power outlets to avoid exposure to high energy levels that can cause burns when parts are short-circuited by metal objects such as tools or jewelry.

5.Label each cable, if not already labeled, to expedite reassembly.

6.Disconnect telecommunication cables to avoid exposure to shock hazard from ringing voltages.

7.Open the server according to the instructions described in your server manual.

Installing the remote management card on ProLiant ML110 G3 servers

1.Remove the access panel.

2.Lay the server on its unexposed side to access the system board.

3.Locate the remote management card connectors on the system board.

4.Install the remote management card in the connectors on the system board.

5.Reinstall the system covers following the "Post-installation procedures (on page 9)".

Installation 8

Image 8

Contents HP ProLiant Lights-Out 100 Remote Management User Guide Audience assumptions Contents Acronyms and abbreviations Index Server management features Operational overview User guide overview Server managementOperational overview Pre-installation procedures InstallationRemote management card kit contents Installation Post-installation procedures Installation Establishing user accounts ConfigurationConfiguring network access Using the serial port Enabling serial access to the LO100Using TCP/IP over Ethernet management port LO100 serial port configurationObtaining a Dhcp IP address from the Bios Setup Utility Selecting an Ethernet management portSetting up a static IP address from the Bios Setup Utility Enabling telnet and Http servicesRompaq /D infile outfile Updating the firmwareUpdating the firmware remotely Tftp settings Configuration Using LO100 SSL overviewSSH overview Ssh -l loginname ipaddress/dns namePutty.exe -ssh -telnet -rlogin -raw user@host Creating a certificate Installing a certificate or private key through the CLPImporting a certificate Using CLP Help o load o reset o setCLP overview Load -source URI -oemhpfiletype keyBase commands Show Start Stop Exit VersionHelp/-h All/-a Help show Usage show targetoptionsproperties Show -hShow -help Usage show targetoptionsproperties Using LO100 Rompaq /D infile outfile Map1/- version Version Specific commandsIpmi 2.0 support Logging in to LO100 Logging in through a web browserBrowser main menu options Logging in through the CLPControlling server power remotely Hardware InventoryControlling server power from a browser Controlling server power through the CLPSystem1/ reset System1 reset System1/ start /system1 System1 startedControlling server power through the Bios Setup Utility Viewing sensors data from the Bios Setup UtilityMonitoring sensors Viewing sensors data from a web browserPlatform event filtering configuration Using the system event log Accessing the system event log from a web browserEnter cd /./system1/log1 Accessing the system event log from the CLPAccessing the system event log from the Bios Setup Utility Configuring network settings using the CLP Network settingsConfiguring network settings using a web browser Configuring network settings using the Bios Setup Utility Using the virtual floppy feature Configuring the Tftp Server Configuring virtual floppy from a Web browserSet oemhpvsitftpserver=10.12.52.142 Configuring the virtual floppy from the Bios setupConfiguring virtual floppy from the CLP Platform event trap configuration Rebooting the serverSet oemhpvsipath=rboot Set oemhpvsipermission=rwUser administration Changing user settings through a web browserBios console text redirection through telnet Accessing the remote console through telnetChanging user settings through the CLP Linux console redirection Microsoft Windows EMS management S012345respawn/sbin/agetty -L 115200 ttyS0 vt102HP SIM support Acronyms and abbreviations KCS SSL Index ROMPaq utility Safety considerations Index