2 Hardware Changes
General Hardware Installation Sequence
To ensure the proper installation thin client hardware components:
1.Back up any data, if necessary.
2.If the thin client is powered on:
a.Turn off the computer properly through the operating system, then turn off any external devices.
b.Disconnect the power cord from the power outlet and disconnect any external devices.
c.Disconnect any external devices or cables, such as a cable lock.
WARNING! To reduce the risk of personal injury from electrical shock and/or hot surfaces, be sure to disconnect the power cord from the wall outlet and allow the internal system components to cool before touching.
WARNING! To reduce the risk of electrical shock, fire, or damage to the equipment, do not plug telecommunications or telephone connectors into the network interface controller (NIC) receptacles.
CAUTION: Static electricity can damage the electronic components of the thin client or optional equipment. Before beginning these procedures, ensure that you are discharged of static electricity by briefly touching a grounded metal object. See Electrostatic Discharge on page 30 for more information.
3.Remove the secure USB compartment cover. See Removing and Replacing the Secure USB Compartment Cover on page 12 for more information.
4.Remove the side access panel and metal side cover. See Removing and Replacing the Side Access Panel and Metal Side Cover on page 14 for more information.
5.Remove any hardware that you will replace.
6.Install or replace equipment. For removal and replacement procedures, see the following sections:
●Installing the USB Device on page 16
●Removing and Replacing the Battery on page 17
NOTE: Option kits include more detailed installation instructions.
General Hardware Installation Sequence 11