HP 2760p manual System Configuration menu

System Configuration menu

NOTE: Some of the listed System Configuration options may not be supported by your computer.

Select	To do this
Language	Change the Computer Setup language.
Boot Options	●	Set a startup menu delay (in seconds).
	●	Set the MultiBoot Express popup delay (in seconds).
	●	Enable/disable custom logo (disabled by default).
	●	Enable/disable display diagnostic URL (enabled by
		default).
	●	Enable/disable CD-ROM boot (enabled by default).
	●	Enable/disable SD card boot (enabled by default).
	●	Enable/disable floppy boot (enabled by default).
	●	Enable/disable PXE internal NIC boot (enabled by
		default).
	●	Enable/Disable Unified Extensible Firmware Interface
		(UEFI) Boot Mode (disabled by default).
	●	Set the legacy boot order.
Device Configurations	●	Enable/disable USB legacy support (enabled by default).
		When enabled, USB legacy support allows the following:
		◦	Use of a USB keyboard in Computer Setup even
			when a Windows operating system is not running
		◦	Startup from bootable USB devices, including a
			hard drive, diskette drive, or optical drive
			connected by a USB port to the computer
	●	Enable/disable fan always on while connected to an AC
		outlet (disabled by default).
	●	Enable/disable Data Execution Prevention (select models
		only). When enabled, the processor can disable some
		virus code execution, which helps to improve computer
		security (disabled by default).
	●	Select a SATA (Serial Advanced Technology Attachment)
		device mode. The following options are available:
		◦	AHCI (Advanced Host Controller Interface)
		◦	IDE (Integrated Drive Electronics)
		◦	RAID (Redundant Array of Independent Disks) (select
			models only)

90 Chapter 5 Computer Setup