HP 8 Pro 7600us, 8 Pro 7600ca manual Board cable

Page 22

4.Remove the display panel cable (3).

Reverse this procedure to install the display panel cable.

I/O board cable

Description

Spare part number

 

 

I/O board cable

743830-001

 

 

Before removing the I/O board cable, follow these steps:

1.Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and then shut it down through the operating system.

2.Disconnect the power from the tablet by unplugging the power cord from the tablet.

3.Disconnect all external devices from the tablet.

4.Remove the back cover (see Back cover on page 13).

16

Chapter 5 Removal and replacement procedures

Image 22
Contents HP Slate8 Pro Product notice Safety warning notice Iv Safety warning notice Table of contents Specifications Power cord set requirements Product description PanelProduct description External component identification External component identification Illustrated parts catalog Locating the serial number, product number, and model numberTablet major components LTE antennaMiscellaneous parts Sequential part number listingIllustrated parts catalog Service considerations Removal and replacement preliminary requirementsTools required Grounding guidelines Electrostatic discharge damagePackaging and transporting guidelines Equipment guidelines Tablet component replacement procedures Removal and replacement proceduresBack cover Display panel cable Page Board cable Page Battery Page Board Speakers Page Wlan antenna Page GPS antenna Page Microphone Page Rear-facing webcamera Page Front-facing webcamera Power button board Page Page Volume button board Page LTE antenna System board Page Page Page Specifications Requirements for all countries Power cord set requirementsRequirements for specific countries and regions Power cord set requirements Recycling Index HdmiTablet