HP 8 Pro 7600us, 8 Pro 7600ca manual

Page 30

4.Detach the WLAN main antenna transceiver (3) from the display panel assembly. (The WLAN main antenna transceiver is attached to the display panel assembly with double-sided adhesive.)

5.Remove the WLAN main antenna transceiver and cable.

NOTE: Steps 6 through 9 contain WLAN auxilliary antenna removal information. See steps 2 through 5 for WLAN main antenna removal information.

6.Disconnect the WLAN auxilliary antenna cable (1) from the auxilliary terminal on the system board.

7.Release the WLAN auxilliary antenna cable from the routing clips (2) and channel built into the display panel assembly.

24	Chapter 5 Removal and replacement procedures

Image 30

Contents HP Slate8 Pro Product notice Safety warning notice Iv Safety warning notice Table of contents Specifications Power cord set requirements Product description PanelProduct description External component identification External component identification Illustrated parts catalog Locating the serial number, product number, and model numberTablet major components LTE antennaMiscellaneous parts Sequential part number listingIllustrated parts catalog Removal and replacement preliminary requirements Service considerationsTools required Grounding guidelines Electrostatic discharge damagePackaging and transporting guidelines Equipment guidelines Removal and replacement procedures Tablet component replacement proceduresBack cover Display panel cable Page Board cable Page Battery Page Board Speakers Page Wlan antenna Page GPS antenna Page Microphone Page Rear-facing webcamera Page Front-facing webcamera Power button board Page Page Volume button board Page LTE antenna System board Page Page Page Specifications Power cord set requirements Requirements for all countriesRequirements for specific countries and regions Power cord set requirements Recycling Index HdmiTablet