HP ST-C5USBVA-300, ST-C5USBV-300 manual Plug-in and Boot Up, Nti

Yellow CommunicationLED

Green Power LED

(Front View)

Connect the CAT5 cable

Connect the CAT5 cable to the “CAT5” port on the rear of the Remote Unit (see Fig. 8). (If an RJ45 wall outlet is being used, connect the other end of the extension cable to it.) When properly inserted the cable end should snap into place.

WARNING: Never connect the ST-C5USBV-300 ! Extender to an Ethernet card, Ethernet router,

hub or switch or other Ethernet RJ45 connector of an Ethernet device. Damage to devices connected to the Ethernet may result.

ST-C5USBV-300 Remote Unit

- +

NTI R

Network Technologies Inc

XTENDEX USB

CAT5 Cable to

Local Unit

Figure 8- Connect CAT5 cable to the Remote Unit

Plug-in and Boot Up

1.Plug the power cord(s) from the monitor(s) into power outlet(s).

2.Connect the AC adapter power connectors to the 9VDC ports on the Remote and Local Units. (AC adapter shown in Fig. 9)

3.Plug the AC adapters into power outlets. The “Power” LED (Green) on the CAT5 connector of each unit should illuminate, indicating that a proper power connection has been made.

4.Turn ON the CPU and monitor(s). The CPU and monitor(s) should each react as if they were directly connected to each

other. The yellow communication LEDs on the Remote and Local Units (see Fig. 8) should blink indicating there is proper communication between them.

Note: A loss of signal (blank screen) may be experienced for an instant during the auto- compensation process after powering-up (ST- C5USBVA model only). This may also occur if the XTENDEX senses a loss of or weak signal connection in the CAT5 cable.

USB	XTENDEX
Inc Technologies Network

RNTI

(Rear View)

ST-C5USBV-300

Remote Unit

+ -

9 VDC

Adapter

ADAPTER

Barrel

Power Connector

9VDC @ 1.0A OUTPUT

(Outside	(Inside
barrel)	barrel)

2.1 mm x 5.5 mm Female

Figure 9- Connect AC adapters

9