HP HN220E manual Connecting the 5-port switch

connecting the 5-port switch

1Verify that all of the box components are included.

2Remove the Ethernet 5-Port Switch and AC Power Adapter from the box.

3Plug the power cable into the POWER port on rear panel of the 5-Port Switch as shown in the diagram on the following page.

4Plug the other end of the Power Adapter into an AC wall outlet.

5Make connections according to these options:

■Network-ready devices (such as computers, print servers, or the HP Digital Entertainment Center). Add these devices to your Ethernet network by connecting the Ethernet cable coming from each device to one of the five blue LAN ports on the rear panel—see cabling diagram. Do not plug these devices into the UPLINK port.

2

■Network infrastructure devices (such as a hub, Gateway, or another switch). Connect the Ethernet cable coming from the device to the yellow UPLINK port of the 5-Port Switch. Since the UPLINK port shares wiring with port 5, port 5 will be disabled if a cable is plugged into the UPLINK port (and vice versa). See the cabling diagram in this quick start guide as well as the diagram on the underside of the Ethernet 5-Port Switch.

Note: If the second device also has an uplink port, do not connect its uplink port to the UPLINK port on the 5-port switch. You may use the uplink port on either device, but the other end of the cable must go to a standard Ethernet port on the other device.

Filename: QS Ethernet 5-Port Switch.doc			Title: HP-Print2k.dot
Template: quick_ref_template.dot		Author: Elizabeth Stoneburg		Last Saved By: Elizabeth Stoneburg
Revision #: 17	Page: 2 of 9	Printed: 09/14/01 03:01 PM