JVC MX-G50 manual Getting Started, 6, Unpacking, Connecting Antennas, coaxial terminal, FM antenna

Getting Started

Continued

Unpacking Connecting Antennas

After unpacking, check to be sure that you have all the following items.

The number in the parentheses indicates the quantity of the pieces supplied.

•AM loop antenna (1)

•FM antenna (1)

•Remote control (1)

•Batteries (2)

If any is missing, consult your dealer immediately.

FM antenna

FM antenna (supplied)

ANTENNA AM

FM [75 ]

Putting the Batteries into the Remote Control

Insert the batteries — UM-4/AAA/IEC R03 — into the	1	Attach the FM antenna to the FM [75 Ω]
remote control, by matching the polarity (+ and –) on the		coaxial terminal.
batteries with the + and – markings on the battery	2	Extend the FM antenna.
compartment.
When the remote control can no longer operate the unit,	3
replace both batteries at the same time.		Fasten it up in the position which gives you
		the best reception, then fix it on the wall, etc.
1
		About the supplied FM antenna
	The FM antenna supplied with this unit can be used as temporary
	measure. If reception is poor, you can connect an outdoor FM
	antenna.

To connect an outdoor FM antenna

Before connecting it, disconnect the supplied FM antenna.

				Outdoor FM antenna
	2			(not supplied)
		UM-4/AAA/IEC R03
3		-
		+
		+
		-
						ANTENNA	AM
				FM	[75	]
•	DO NOT use an old battery together with a new one.
• DO NOT use different types of batteries together.			A 75	Ω antenna with coaxial type connector should be
•	DO NOT expose batteries to heat or flame.
			used.
• DO NOT leave the batteries in the battery
	compartment when you are not going to use the
	remote control for an extended period of time.
	Otherwise, it will be damaged from battery leakage.
			– 6 –