| 55 |
Table | |
|
|
Field | Description |
In Part Enforce | Boolean value that indicates whether or not to support optional |
| partition enforcement for the packets received by this port. |
| There is no default value. |
|
|
Out Part Enforce | Boolean value that indicates whether or not to support optional |
| partition enforcement for the packets transmitted by this port. |
| There is no default value. |
|
|
In Filter Raw Packet Enforce | Boolean value that indicates whether or not to support optional |
| raw packet enforcement for the raw packets received by this |
| port. There is no default value. |
|
|
Out Filter Raw Packet | Boolean value that indicates whether or not to support optional |
Enforce | raw packet enforcement for the raw packets transmitted by this |
| port. There is no default value. |
|
|
MKey Violation | Number of subnet management packets (SMPs) that have been |
| received on this port with invalid M_Keys since initial powerup |
| or the last reset. Refer to section 14.2.4, Management Key, |
| “InfiniBand® Architecture, Vol. 1, Release 1.0”, for more |
| information. |
|
|
PKey Violation | Number of SMPs that have been received on this port with |
| invalid P_Keys since initial powerup or the last reset. Refer to |
| section 9.2.7, partition key (P_KEY), “InfiniBand® |
| Architecture, Vol. 1, Release 1.0”, for more information. |
|
|
QKey Violation | Number of SMPs that have been received on this port with |
| invalid Q_Keys since initial powerup or the last reset. Refer to |
| section 10.2.4, Q Keys, “InfiniBand® Architecture, Vol. 1, |
| Release 1.0”, for more information. |
|
|
GUID Cap | Number of GUID entries allowed for this port in the port table. |
| Any entries that exceed this value are ignored on write and read |
| back as zero. Refer to section 14.2.5.5, GUIDCap, |
| “InfiniBand® Architecture, Vol. 1, Release 1.0”, for more |
| information. |
|
|
Subnet Timeout | Maximum propagation delay allowed for this port to reach any |
| other port in the subnet. This value also affects the maximum |
| rate at which traps can be sent from this port. Delay is affected |
| by switch configuration. This parameter, along with |
| may be used by requestors to determine the interval to wait for a |
| response to a request before taking other action. Duration is |
| calculated as (4.096 ms * 2^SubnetTimeout). |
|
|
Response Time | Maximum time allowed between the port reception of a subnet |
| management packet and the transmission of the associated |
| response. Refer to section 13.4.6.2, Timers and Timeouts, |
| “InfiniBand® Architecture, Vol. 1, Release 1.0”, for more |
| information. |
|
|
Local Physical Error | Threshold at which ICRC, VCRC, FCCRC, and all physical |
| errors result in an entry into the BAD PACKET or BAD |
| PACKET DISCARD states of the local packet receiver. Refer to |
| section 7.12.2, Error Recovery Procedures, “InfiniBand® |
| Architecture, Vol. 1, Release 1.0”, for more information. |