HP Serviceguard Toolkit for Integrity Virtual Servers Using SG IVS Toolkit commands, Servicename

Attributes	Description
MAINTENANCE_FLAG	This attribute is used to indicate if the VM or vPar guest
	package can run in maintenance mode. The default
	value is [yes].
MONITOR_INTERVAL	This is the time interval (in seconds) between the monitor
	cycles and the default value is 30 seconds. The toolkit
	monitors the health of the package every
	[MONITOR_INTERVAL ]seconds.
service_name	Name of the service that Serviceguard monitors while
	the package is up. This name must be unique for VM
	or vPar guest package in a Serviceguard cluster. The
	default name for a VM and vPar package is vm_name
	and vpar_name, respectively. When you use the
	cmdeployvpkg command, <vm_name> or
	<vpar_name> is added as the value of this attribute.

5.After the package configuration file is edited, save the file.

6.To validate the package configuration file, run the command: cmcheckconf –P pkg.conf

7.To apply the package configuration file if the cmcheckconf command succeeds, run the command:

cmapplyconf -P pkg.conf

Confirm if you want to modify the package configuration. The default value is [yes]

8.To enable auto run and package failover, run the following commands:

•$ cmmodpkg -e -n <node_1>...-n <node_n> <package name>

•$ cmmodpkg -e <package name>

9.To check the status of the package, run the command: cmviewcl.

Using SG IVS Toolkit commands

The cmdeployvpkg command assists you to create and manage Serviceguard package configurations for HP Integrity VM and HP-UX vPars. This command automates the configuration steps performed using the Serviceguard commands.

Run cmdeployvpkg -P <vm/vpar_name> [....] to configure the VM or vPar as a

Serviceguard package.

Before applying the configuration, you must review the generated package configuration file, to ensure that correct logical volumes, mount points are identified and included in the package configuration files.

The cmdeployvpkg command:

•Verifies the Serviceguard cluster environment.

•Verifies the VM or vPar environment.

•Identifies the Serviceguard modules and attribute values.

•Creates a Serviceguard package configuration file.

•Configures a set of HP Integrity servers grouped into a VM or vPar multi server environment.

After you run the cmdeployvpkg command, to package a guest containing CVM or CFS backing store entries, review and modify the package configuration file.

For more information on cmdeployvpkg command, see the cmdeployvpkg(1) manpage.

16 Using SG IVS toolkit