(substitute your release directory if it's different from 11.23). If the make_depots command returns quickly with no errors, the depot already exists on the system.
Procedure
Run the make_depots command below for all DVDs in the OE set. Remember to substitute your device file name and the appropriate release directory (Rel_B.11.xx) for your version of
#/opt/ignite/bin/make_depots
Common Errors
ERROR: swcopy command failed
Diagnosis: Read the file /var/opt/ignite/depots/Rel_B.11.23/core_media/swagent.log to get a full report of what went wrong.
make_depots: error — cannot stat source depot /dev/dsk/cntndn
make_depots: notice — Ending make_depots due to fatal error
Diagnosis: The wrong device file was used.
Correction: Reissue the make_depots command with the correct device file.
Explore
You can watch the depot creation process by listing the file /var/opt/ignite/depots/Rel_B.11.23/ core_media/swagent.log with the following command.
#tail
The depot will be put in the /var/opt/ignite/depots/Rel_B.11.23 directory and will be named core_media.
This process is described fully in the section on installation configurations using Software Distributor
The depot we're creating is called core_media in order to distinguish it from other depots of the same
Create the
1.Create the configuration file, named core_media_cfg, to describe this
If you want more than one configuration available for a version of
If you wish, you may safely complete the section “Configure the System as an
Procedure
#/opt/ignite/bin/make_config
Common Errors
12 Setting up an