TCL Air Conditioner Service Manual
Operation Details
1Remote controller
Remote controller
The remote controller transmits signals to the system.
5
2
8
4
SLEEP TIMER ON TMIER OFF
FEELAUTO
COOL | HIGH |
DRYMID
FANLOW
HEATSWING
SLEEPFAN
TIMERSWING
MODEON/OFF
3
7
6
1
1ON/OFF button
Used to start and stop operation when pressed.
2TIMER button
Used to select TIMER operation.
3UP button (TOO COOL button)
Used to increase the set room temperature
and time.
4DOWN button (TOO WARM button)
Used to decrease the set room temperature and time.
5SLEEP button
Used to set or cancel sleep mode operation.
6VANE control button
Used to adjust airflow direction.
7FAN SPEED control button
Used to select the indoor fan motor speed:
Auto, High, Mid and Low.
8 MODE button
Used to select the type of operation mode: Feel,
Cooling, Dry, Fan and Heating(Only for Heat Pump).
Note: Each mode and relevant function will be further specified in following pages.
Remote Control
The remote controller is not preset as Cooling Only Air Conditioner or Heat Pump by manufacturer.
Each time after the remote controller replace batteries or is energized, the arrowhead will flash on the front of
Heat or | Cool on LCD of the remote controller. |
|
|
User can preset the remote controller type depending on the air conditioner type you have purchased as | |||
follows: |
|
|
|
Press any button when the arrowhead flashes on the front of | Cool | , Cooling Only is set. | |
Press any button when the arrowhead flashes on the front of | Heat | , Heat Pump is set. | |
If you don | t press any button within 10 seconds, the remote controller is preset as Heat Pump automatically. |
Note :
If the air conditioner you purchased is a Cooling Only one, but you preset the remote controller as Heat Pump, it doesn t matter. But if the air conditioner you purchased is a Heat Pump one, and you preset the remote controller as Cooling Only, then you CAN NOT preset the Heating operation with the remote controller.
4