Where to Go From Here
You are now finished installing the Remote 2C. Software configuration for the AdvanceStack Internet Router is needed. See that manual now.
Removing A Module from the Remote 2C
The module is removed from the Remote 2C by reversing the installation steps described earlier in this guide. To remove the module, follow these steps:
1.Disconnect any cables connected to the module(s).
2.Unscrew the two captured screws holding the module.
3.Pull the extractor handles up.
4.Pull the module out of the slot. The following illustration shows the removal of the HP Internet Router Module from the Remote 2C.
Caution: Replace the cover plate over the slot using the two screws that hold it in place. Be careful not to overtighten the screws. When using the Remote 2C without a module, the cover plate must always be installed. This is required not only for safety, but also to ensure proper cooling.
Note: When you remove a module, the other module is not reset.
12