HP AdvStack Remote 2C & Internet Bundle Safety and Regulatory Statements, Mounting Precautions

Page 25

Safety and Regulatory Statements

This chapter covers the following topics:

mounting precautions

power precautions

safety and regulatory statements

Declaration of Conformity

Mounting Precautions

When you put the Remote 2C into a rack, follow these mounting precautions:

The rack or cabinet should be adequately secured to prevent it from becoming unstable and/or falling over. The first unit (e.g, hub, switch, or Remote 2C) should be mounted in a position toward the bottom of the rack for stability and to make it easier to stack the other products on top.

Before mounting a Remote 2C, plan its location and orientation relative to other devices and equipment. Also consider the cabling that will be attached to the Remote 2C and the ports that will be used. Verify that there is room for the grouped cables to trail out from the side of the Remote 2C. Allow at least 2.54 cm (1 inch) in the front of the Remote 2C. In the back of the Remote 2C, allow at least 3.8 cm (1 1/2 inches) of space for the power cord.

Ensure that the Remote 2C does not overload the power circuits, wiring, and over-current protection. To determine the possibility of overloading the supply circuits, add together the amperage ratings from the name- plates of all the other equipment installed on the same circuits and compare the total with the rating limits for the supply circuits.

Make sure that the power source circuits are properly grounded, then use the supplied power cord to connect the Remote 2C to the circuit. See the Safety Statements in this chapter.

Do not install the Remote 2C in an environment where the operating ambient temperature might exceed 55°C (131°F).

Make sure the air flow around the sides of the Remote 2C is not restricted.

Make sure to reinstall the cover plate over any open module slots. This is required not only for safety, also to ensure proper cooling.

17

Image 25
Contents HP J3257A Page HP AdvanceStack Remote 2C Installation and Reference Guide Publication Number WarrantyApplicable Product DisclaimerContents Page HP First Fax Retrieval Service HP Customer Support ServicesWorld Wide Web Location Phone NumberAdditional HP Support Services Installing the HP AdvanceStack Remote 2C Verifying Included Parts Warranty booklet Power cord, one of the followingMounting the Remote 2C Upperholeinthebracket Lower notch in the bracket Mounting the Remote 2C on a Wall Installing a Module into the Remote 2C Connecting Cables From the Remote 2C To the Office LAN Remote 2C Ethernet Hub-12R If you have the following topology Connecting Power using an RPS or AC PowerAfter Self Test During Self TestLEDs For LEDs that are on State Meaning Description of LEDs on the Remote 2CRemoving a Module from the Remote 2C Where to Go From HereProblem Solution Troubleshooting the Remote 2CElectrical PhysicalOperating Environmental SafetyElectromagnetic ImmunitySpecifications Mounting Precautions Safety and Regulatory StatementsSafety and Regulatory Statements Power PrecautionsGrounding Safety InformationServicing Informations concernant la sécurité Hinweise zur Sicherheit Considerazioni sulla sicurezza Resultar en averías al equipo Consideraciones sobre seguridadSafety Information Japanese FCC Class a Statement for U.S.A. Only Regulatory StatementsEuropean Community CanadaDeclaration of Conformity Page J3257-90004