HP V8.5 manual Specification S

Page 14

2

S P E C I F I C A T I O N S

~Form feed adjust F2, F4, F8, tF, PF - selects formfeed of 2, 4, 8 inches, Top of Form sensing, and programable past top of form respectively.

~Bytes per scan b1, b2 - selects 216 and 264 bytes per scan respectively.

~Grayscale levels per scan g1, g2, g3, g4 - selects 8, 16, 32, and 64 levels of gray levels per scan respectively.

#Grayscale media calibration table number t1, t2.

Settings marked with (*) are used exclusively with bi-modal plotting. Settings marked with (#) are used exclusively with grayscale plotting. Settings marked with (~) are used with both bi-modal and grayscale plotting.

Plot speeds	Paper 1.0, 2.0, 3 .0, and 4.0 inches per second
	in bimodal (black and white) plotting mode.
	Film: 1.0 inch per second.
	Grayscale: dependent upon the number of levels
	of grayscale selected.

Condition detection Media out. Top of form. Head temperature.

24 volt error detection.

2- 2	V8.5eRev2.2.2002

Image 14

Contents V8.5 Thermal Plotter Disclaimer Copyright NoticeTrademarks HaftungsausschlussPage Iii V8.5eRev2.2.2002 Limitation of Liability Contents Operation Maintenance AppendicesV8.5eRev2.2.2002 General Description Media DescriptionAbout this Manual Functional OperationSpecification S Media Interface TransportElectrical Physical EnvironmentalInstallation UnpackingMounting and Positioning Interface Setup Media InstallationInstalling rolled paper Back Panel Roll paper and film path Opening the plotter Lid Installing fan-fold paper Installing rolled film Spindle blocks Power Supply Precautions E R a T I O NUsing the Control Panel Control panelControl panel button functions Rev2.2.2002 Control Panel Functions and Settings Changing function settingsContrast Default SettingsTestplot Speed Media Scaling Form feed length Emulation vertical resolutionMenusettingsareF2, F4, F8, tF,PF E R a T I O N Menusettingsare b1, b2, g1, g2, g3, and g4 Bytes per scanSetup headers for programming the V8.5e Grayscale media table numberSA=4B E R a T I O N Error Messages Byte Line feedFehlermeldungen Introduction Plotter Functions and FeaturesPower supplies T I O N Interface Interface timing and signalsStepper motor Data Transfer Clear Data rates Minimum data ratesVerticalresolution Scan widthPrint mode Mode signalsAutomatic Head Temperature Feedback Thermal PrintheadFilm media Media SensorsMaintenance Maintenance Guidelines I N T E N a N C ERegular Maintenance Cleaning the thermal printhead Cleaningtheplatenroller Replacing the fuse Troubleshooting Problems Plotter does not plotPlot has vertical white stripes PlotwithverticalwhitestripesPlot is blotchy or faded Plot contrast is weak Solution PlothasblackverticallinesPlot is wrong length Paper is wrinkling or tearing along one edgePlotter has no power Can’t make changes to control panel settingsPlot output speed is erratic Bloomingplot Form feed stops before desired length Form feed does not stop at top-of-form marksPlot is skewed or unreadable SkewedplotR R a N T Y R R a N T Y C I I T a B L E S Interface Connector PIN Assignment TableB-2. Centronicscablepinoutsstraightthrough Centronics Interface Board Centronics Interface Board Centronics Interface Board