HP V8.5 manual Plotter has no power, Can’t make changes to control panel settings

Page 68

7

T R O U B L E S H O O T I N G

3.If the lid does not close securely, or if the head pressure is too low, contact your authorized service center.

Plotter has no power

Possible Cause: If the plotter is plugged in to a functioning outlet, then the AC fuse has blown.

Solution:

1.Replace the fuse as described in Chapter 6.

Plotter display is functioning but motor does not function

Possible Cause: Either the 5 V or 24 V power supply is

malfunctioning.

Solution:

1.Contact your authorized service center.

Can’t make changes to control panel settings

Possible Cause: Plotter is in ONLINE mode.

Solution:

1.Press the ON/OFFLINE button.

7-8

V8.5eRev2.2.2002

Image 68
Contents V8.5 Thermal Plotter Copyright Notice TrademarksDisclaimer HaftungsausschlussPage Iii V8.5eRev2.2.2002 Limitation of Liability Contents Operation Maintenance AppendicesV8.5eRev2.2.2002 General Description Media DescriptionAbout this Manual Functional OperationSpecification S Media Interface TransportElectrical Physical EnvironmentalInstallation UnpackingMounting and Positioning Interface Setup Media InstallationInstalling rolled paper Back Panel Roll paper and film path Opening the plotter Lid Installing fan-fold paper Installing rolled film Spindle blocks Power Supply Precautions E R a T I O NUsing the Control Panel Control panelControl panel button functions Rev2.2.2002 Control Panel Functions and Settings Changing function settingsContrast Default SettingsTestplot Speed Media Scaling Form feed length Emulation vertical resolutionMenusettingsareF2, F4, F8, tF,PF E R a T I O N Menusettingsare b1, b2, g1, g2, g3, and g4 Bytes per scanSetup headers for programming the V8.5e Grayscale media table numberSA=4B E R a T I O N Error Messages Byte Line feedFehlermeldungen Introduction Plotter Functions and FeaturesPower supplies T I O N Interface Interface timing and signalsStepper motor Data Transfer Clear Data rates Minimum data ratesVerticalresolution Scan widthPrint mode Mode signalsAutomatic Head Temperature Feedback Thermal PrintheadFilm media Media SensorsMaintenance Maintenance Guidelines I N T E N a N C ERegular Maintenance Cleaning the thermal printhead Cleaningtheplatenroller Replacing the fuse Troubleshooting Problems Plotter does not plotPlot has vertical white stripes PlotwithverticalwhitestripesPlot is blotchy or faded Plot contrast is weak Solution PlothasblackverticallinesPlot is wrong length Paper is wrinkling or tearing along one edgePlotter has no power Can’t make changes to control panel settingsPlot output speed is erratic Bloomingplot Form feed stops before desired length Form feed does not stop at top-of-form marksPlot is skewed or unreadable SkewedplotR R a N T Y R R a N T Y C I I T a B L E S Interface Connector PIN Assignment TableB-2. Centronicscablepinoutsstraightthrough Centronics Interface Board Centronics Interface Board Centronics Interface Board