Soleus Air SG-WAC-12HCE operating instructions Using Your AIR Conditioner

Page 15

USING YOUR AIR CONDITIONER (Cont.)

Freezing Conditions: This is a cooling only air conditioner. It is not designed for freezing outdoor conditions. It must not be used in freezing outdoor conditions.

Remote Control: To ensure proper operation when using the remote control, aim the remote directly at the signal receiver on the air condi- tioner.

The remote control has a signal range up to 20 feet.

Make sure nothing is blocking the remote con- trol signal from being received by the air con- ditioner.

Make sure the batteries are installed correctly and still have power.

Cooling Mode: Use the COOL mode at Low, Me- dium, High, or Auto Fan speed when cooling is needed. Use the temperature ▲/▼ buttons to set the desired temperature between 64°F and 86°F.

Once the temperature is set, the compressor will cycle on and off to keep the room temperature at the set temperature level. The lower the set thermostat temperature, the cooler the room will become. The higher the set thermostat temperature, the warmer the room will become.

For Normal Cooling - Set the Mode to Cool and the Fan to High or Med with the termperature set in the middle.

For Maximum Cooling - Set the Mode to Cool and the Fan to High with a lower set temperature.

For Quieter & Nighttime Cooling - Set the Mode to Cool and the Fan to Low with the temperature set in the middle.

NOTE: If the air conditioner is off and is then turned on while set to a Cool setting or if turned from a fan setting to a Cool setting, it may take approximately 3 minutes for the compressor to start and cooling to begin.

Heat Mode: Use the Heat mode at Low, Med, High or Auto Fan Speed for heating. Use the temperature ▲/▼ buttons to set the desired temperature between 64°F and 86°F in 1°F increments.

For Normal Heating - Set the Mode to Heat and the Fan to High or Med with the termperature set in the middle.

For Maximum Heating - Set the Mode to Heat and the Fan to High with a lower set temperature.

For Quieter & Nighttime Heating - Set the Mode to Heat and the Fan to Low with the temperature set in the middle.

Energy Saver Mode - Controls the Fan

On - The fan will cycle on and off with the compressor. This results in winder variations of room temperature and humidity. Normally used with the room is unoccupied. NOTE: The fan my continue to run for a short time after the compres- sor cycles off.

Off - The fan runs all the time in fan or cooling mode.

Fan Only Mode: Use Fan Only mode at Low, Med, or High fan speed to provide air circulation and filtering without cooling. Since fan only setting do not provide cooling, a Set temperature cannot be entered. The room temperature will appear in the display.

NOTE: Auto Fan Speed cannot be used in Fan Only mode.

Loss of Power Protection: If power to the air conditioner is lost or interrupted, the air condi- tioner will automatically re-start in the setting last used prior to power loss. If the Timer was set to automatically turn the air conditioner off or on, it will resume countdown at the amount time left prior to power loss. You may need to set a new time if desired.

Air Direction: Use the lever near on the front air vents to adjust the direction of the airflow. You can direct the airflow left or right only. The lever is located on the right side of the air vent.

15

Image 15
Contents SG-WAC-12HCE Important Safety Instructions Lcdi Power Cord and Plug Electrical RequirementsRecommended Ground Method Location Requirements Parts List Tools NeededModel SpecificationsStorm Window Requirements Installation & Assembly InstructionsPrior to Installing the Air Conditioner Window PreparationRemove Chassis Installation & Assembly Instructions Window MountingInstallation & Assembly Instructions Window Mounting Foam Gasket and Top Assembly & InstallationTop Angle Rail and Side Bracket Installation Placing the Cabinet Inside the WindowExtend the Accordion Panels Install the Window Lock and Sash SealPrepare the Wall THRU-THE-WALL InstallationInstalling the Chassis into the Cabinet Select the Wall LocationPrepare and Install the Cabinet Assembly & Installation THRU-THE-WALLSupport Bracket Wooden Strip Masonry ConstructionNormal Operating Sounds Using Your AIR ConditionerElectronic Control Panel & Remote Control Remote ControlUsing Your AIR Conditioner Using Your AIR Conditioner Winter Storage Care and CleaningAir Filter Cleaning Cabinet CleaningTroubleshooting Water is dripping outside Water is dripping inside the roomWater collects in the base pan One Year Limited Warranty Warranty
Related manuals
Manual 20 pages 12.18 Kb

SG-WAC-12HCE specifications

The Soleus Air SG-WAC-12HCE is a powerful and efficient window air conditioning unit designed to provide a comfortable indoor climate even during the hottest summer months. With its sleek design and effective cooling capabilities, this air conditioner has gained popularity among consumers looking for reliability and performance.

One of the standout features of the Soleus Air SG-WAC-12HCE is its 12,000 BTU cooling capacity, making it suitable for medium to large rooms up to 550 square feet. This powerful cooling performance is complemented by a dehumidification mode, which can remove up to 3.5 pints of moisture per hour. This combination ensures that not only is the air cooled down but also makes it less humid, providing a more comfortable living environment.

Energy efficiency is another primary characteristic of the SG-WAC-12HCE. With an Energy Efficiency Ratio (EER) of 12.0, this unit is designed to reduce energy consumption while delivering optimal cooling performance. This feature is essential for those looking to keep energy bills in check while maintaining a pleasant indoor atmosphere. The unit is also ENERGY STAR certified, demonstrating its commitment to minimal environmental impact.

The Soleus Air SG-WAC-12HCE comes equipped with an array of user-friendly controls. It features an intuitive remote control, allowing users to adjust the temperature settings, fan speeds, and modes from the comfort of their couch or bed. The electronic controls include a digital display, making it easier to monitor and set the desired cooling levels accurately.

Additionally, this air conditioner offers three cooling speeds and three fan-only speeds, giving users the flexibility to customize their comfort level based on personal preferences and varying weather conditions. The unit also features a programmable 24-hour timer, which allows for scheduled operation, ensuring the air conditioner only runs when needed.

Installation of the SG-WAC-12HCE is straightforward, thanks to the included window installation kit, which makes it compatible with most standard window sizes. Overall, the Soleus Air SG-WAC-12HCE is a feature-rich window air conditioning unit that excels in cooling efficiency, user convenience, and versatility, making it an exceptional choice for consumers looking to stay cool and comfortable.