Soleus Air SG-WAC-25HCE manual Using Your AIR Conditioner

Page 15

USING YOUR AIR CONDITIONER (Cont.)

Freezing Conditions: This is a cooling only air conditioner. It is not designed for freezing outdoor conditions. It must not be used in freezing outdoor conditions.

Remote Control: To ensure proper operation when using the remote control, aim the remote directly at the signal receiver on the air condi- tioner.

The remote control has a signal range up to 20 feet.

Make sure nothing is blocking the remote con- trol signal from being received by the air con- ditioner.

Make sure the batteries are installed correctly and still have power.

Cooling Mode: Use the COOL mode at Low, Me- dium, High, or Auto Fan speed when cooling is needed. Use the temperature ▲/▼ buttons to set the desired temperature between 64°F and 86°F.

Once the temperature is set, the compressor will cycle on and off to keep the room temperature at the set temperature level. The lower the set thermostat temperature, the cooler the room will become. The higher the set thermostat temperature, the warmer the room will become.

For Normal Cooling - Set the Mode to Cool and the Fan to High or Med with the termperature set in the middle.

For Maximum Cooling - Set the Mode to Cool and the Fan to High with a lower set temperature.

For Quieter & Nighttime Cooling - Set the Mode to Cool and the Fan to Low with the temperature set in the middle.

NOTE: If the air conditioner is off and is then turned on while set to a Cool setting or if turned from a fan setting to a Cool setting, it may take approximately 3 minutes for the compressor to start and cooling to begin.

Heat Mode: Use the Heat mode at Low, Med, High or Auto Fan Speed for heating. Use the temperature ▲/▼ buttons to set the desired temperature between 64°F and 86°F in 1°F increments.

For Normal Heating - Set the Mode to Heat and the Fan to High or Med with the termperature set in the middle.

For Maximum Heating - Set the Mode to Heat and the Fan to High with a lower set temperature.

For Quieter & Nighttime Heating - Set the Mode to Heat and the Fan to Low with the temperature set in the middle.

Energy Saver Mode - Controls the Fan

On - The fan will cycle on and off with the compressor. This results in winder variations of room temperature and humidity. Normally used with the room is unoccupied. NOTE: The fan my continue to run for a short time after the compres- sor cycles off.

Off - The fan runs all the time in fan or cooling mode.

Fan Only Mode: Use Fan Only mode at Low, Med, or High fan speed to provide air circulation and filtering without cooling. Since fan only setting do not provide cooling, a Set temperature cannot be entered. The room temperature will appear in the display.

NOTE: Auto Fan Speed cannot be used in Fan Only mode.

Loss of Power Protection: If power to the air conditioner is lost or interrupted, the air condi- tioner will automatically re-start in the setting last used prior to power loss. If the Timer was set to automatically turn the air conditioner off or on, it will resume countdown at the amount time left prior to power loss. You may need to set a new time if desired.

Air Direction: Use the lever near on the front air vents to adjust the direction of the airflow. You can direct the airflow left or right only. The lever is located on the right side of the air vent.

15

Image 15
Contents SG-WAC-25HCE Important Safety Instructions Lcdi Power Cord and Plug Electrical RequirementsRecommended Ground Method Non-Hardware Packing List Parts List Tools NeededSpecifications DisclaimerModel Storm Window Requirements Installation & Assembly InstructionsPrior to Installing the Air Conditioner Window PreparationRemove Chassis Installation & Assembly Instructions Window MountingInstallation & Assembly Instructions Window Mounting Placing the Cabinet Inside the Window Assembly & InstallationTop Angle Rail and Side Bracket Installation TOP ViewMark Install Support BracketsInstall the Window Lock and Sash Seal Extend the Accordion PanelsPrepare the Wall THRU-THE-WALL InstallationInstalling the Chassis into the Cabinet Select the Wall LocationPrepare and Install the Cabinet Assembly & Installation THRU-THE-WALLSupport Bracket Wooden Strip Masonry ConstructionNormal Operating Sounds Using Your AIR ConditionerElectronic Control Panel & Remote Control Remote ControlUsing Your AIR Conditioner Using Your AIR Conditioner Winter Storage Care and CleaningAir Filter Cleaning Cabinet CleaningProblem Possible Causes Solutions TroubleshootingWater is dripping outside Water is dripping inside the roomWater collects in the base pan One Year Limited Warranty Warranty

SG-WAC-25HCE specifications

The Soleus Air SG-WAC-25HCE is a prominent air conditioning unit that effectively combines innovative features with user-friendly technology to deliver superior cooling performance. This window air conditioning unit is designed to keep rooms cool and comfortable, making it ideal for residential settings, small offices, or any space requiring efficient climate control.

One of the main features of the Soleus Air SG-WAC-25HCE is its cooling capacity. With a powerful output of 25,000 BTUs, it is capable of cooling spaces of up to 1,500 square feet, ensuring that even larger rooms can maintain a comfortable temperature during peak summer months. It is equipped with three cooling and fan speeds, allowing users to customize the airflow according to their preferences and needs.

The unit incorporates eco-friendly refrigerant R32, which not only helps reduce environmental impact but also enhances cooling efficiency. The innovative design of the SG-WAC-25HCE ensures that it operates with minimal noise, providing a peaceful environment for activities such as sleeping, working, or relaxation.

Another notable technology featured in the Soleus Air SG-WAC-25HCE is its advanced digital thermostat. The unit allows for precise temperature control, and the remote control feature provides added convenience, letting users adjust settings from across the room. The programmable timer enhances energy efficiency by allowing users to set the air conditioning to operate at specific times, effectively reducing electricity consumption when the space is unoccupied.

The air conditioning unit also features a dehumidification mode, which can remove excess moisture from the air, creating a more comfortable indoor environment during humid conditions. The auto-restart function ensures that the system resumes operation after a power outage, maintaining comfort without the need for manual intervention.

Installation and maintenance of the Soleus Air SG-WAC-25HCE are straightforward, as the unit is designed to fit standard window frames. The washable, reusable air filter makes upkeep easy, ensuring that the air quality remains high and the system operates efficiently.

In summary, the Soleus Air SG-WAC-25HCE blends powerful cooling capability, eco-friendly technology, user-friendly features, and efficient operation, making it a smart choice for anyone seeking reliable air conditioning solutions for larger spaces. With its advanced functionalities and ease of use, it stands out as an excellent air conditioning option in the modern market.