HP 800 manual Using OmniBook Disk Drives Restoring OmniBook Software

Page 21

Using OmniBook Disk Drives

Restoring OmniBook Software

2.If you have a CD-ROM drive, connect it according to the instructions for your operating system. This gives you access to the information on the Recovery CD. Otherwise, use the floppy disk you made.

3.Load the drivers you need from the Recovery CD or from a floppy disk onto the hard-disk drive. Each driver includes instructions for installing it.

1-21

Image 21

Contents HP OmniBook 800 Disk Drives Installation Guide Edition History Contents Page Using OmniBook Disk Drives Using OmniBook Disk Drives Where can I get help? Installing a Floppy Disk Drive Floppy disk drive port To install a floppy disk driveTo insert or remove a floppy disk To remove a floppy disk driveTo remove a hard drive Replacing a Hard DriveUsing OmniBook Disk Drives Replacing a Hard Drive Discharge U T I O N Connectors align here Tuck ribbon cable Down as shown Using OmniBook Disk Drives Replacing a Hard Drive Restoring OmniBook Software To restore WindowsTo restore Windows for Workgroups To restore an alternate operating system Using OmniBook Disk Drives Restoring OmniBook Software Page Troubleshooting If the OmniBook is running If the OmniBook is not runningIf you get an error message during startup Solving Basic ProblemsIf the OmniBook turns off immediately after it turns on If the OmniBook stops respondingIf your operating system is Windows If the OmniBook doesn’t reboot successfully WindowsIf your operating system is MS-DOS or Windows for Workgroups If the OmniBook doesn’t turn on with a fresh battery If you need to recover the online User’s GuideIf your password doesn’t work If you cannot install Windows NTSpecifications and Regulatory Information Specifications and Regulatory Information Temperature Hardware SpecificationsConnections to Peripheral Devices Regulatory InformationJapan CanadaAddress Europe

Related manuals

Manual 246 pages 32.59 Kb

Manual 124 pages 26.67 Kb