HP 800 manual Connectors align here

Page 15

Using OmniBook Disk Drives

Replacing a Hard Drive

2.If your new hard drive is from a different manufacturer than the old one, it may have screws in different positions. Determine which mounting holes you need; then, if necessary, push out rubber screw-hole covers from the inside using a bent paper clip. (From the outside of the computer, insert the rubber covers into the holes you won’t need.)

If your new hard drive has screws in different positions from the old one, you will also need to adjust the insulator sheet. Compare the location of the screw- holes in the new hard drive with those in the insulator sheet. If there is no screw at position A, then unfold the flap at position A, and lay it flat before laying the hard drive down on the insulator.

A

3.Grasp the right flap and pull to the left to engage the connection between the hard drive and the computer. Then fold the protective sheet back over the hard drive.

Connectors align here.

1-15

Image 15
Contents HP OmniBook 800 Disk Drives Installation Guide Edition History Contents Page Using OmniBook Disk Drives Using OmniBook Disk Drives Where can I get help? Installing a Floppy Disk Drive Floppy disk drive port To install a floppy disk driveTo insert or remove a floppy disk To remove a floppy disk driveTo remove a hard drive Replacing a Hard DriveUsing OmniBook Disk Drives Replacing a Hard Drive Discharge U T I O N Connectors align here Tuck ribbon cable Down as shown Using OmniBook Disk Drives Replacing a Hard Drive Restoring OmniBook Software To restore WindowsTo restore Windows for Workgroups To restore an alternate operating system Using OmniBook Disk Drives Restoring OmniBook Software Page Troubleshooting If the OmniBook is running If the OmniBook is not runningIf the OmniBook stops responding Solving Basic ProblemsIf you get an error message during startup If the OmniBook turns off immediately after it turns onIf your operating system is Windows If the OmniBook doesn’t reboot successfully WindowsIf your operating system is MS-DOS or Windows for Workgroups If you cannot install Windows NT If you need to recover the online User’s GuideIf the OmniBook doesn’t turn on with a fresh battery If your password doesn’t workSpecifications and Regulatory Information Specifications and Regulatory Information Temperature Hardware SpecificationsConnections to Peripheral Devices Regulatory InformationJapan CanadaAddress Europe
Related manuals
Manual 246 pages 32.59 Kb Manual 124 pages 26.67 Kb