SECTION 2
INSTALLING THE PRINTER
Section 2 – Installing the Printer
Before using the printer the following must be done:
•Choose a location for the Printer
•Plug in the printer and connect it to the computer
•Install the Inkjet Cartridges
•Set up the feed on the printer
•Install the ASTROJET 2600P/2800P Printer Driver software on the computer
Choose a Location
The printer should be placed on a sturdy worktable or cabinet at least 12 inches from any walls. Protect the printer from excessive heat, dust, and moisture – avoid placing it in direct sunlight.
Connecting the Printer
Plugging in the Printer
Make sure that the main power switch of the AstroJet 2600P/2800P Printer is in the OFF position.
1.Connect one end of the power cord to the rear of the AstroJet 2600P/2800P in the corresponding receptacle.
2.Depending on the version 115 volt or 220 volt, plug the other end into a 115 or 220 Volt AC, 50/60 Hz. Grounded outlet.
CAUTION
Do not use an adapter plug or extension cord to connect the printer to the wall receptacle.
Do not use outlets controlled by wall switches.
Do not use an outlet that shares the same circuit with large electrical machines or appliances.
Connecting to the Computer
Plug the parallel printer cable from your computer into the rear of the printer and latch the two locking clips. You may also connect the printer through a USB connection if you are using Windows ME, 2000, NT, or XP. The cable used to connect the AstroJet 2600P/2800P to the computer must not exceed 6 feet long.
5