HP rp5800 Retail System B Agency Regulatory Notices, Federal Communications Commission Notice

Page 16
B Agency Regulatory Notices

B Agency Regulatory Notices

Federal Communications Commission Notice

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio or television technician for help.

Modifications

The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Hewlett Packard Company may void the user's authority to operate the equipment.

Cables

Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods to maintain compliance with FCC Rules and Regulations.

Declaration of Conformity for Products Marked with the FCC Logo (United States Only)

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1.This device may not cause harmful interference.

2.This device must accept any interference received, including interference that may cause undesired operation.

For questions regarding the product, contact:

Hewlett Packard Company

P. O. Box 692000, Mail Stop 530113

Houston, Texas 77269-2000

Or, call 1-800-HP-INVENT (1-800 474-6836)

10 Appendix B Agency Regulatory Notices

ENWW

Image 16
Contents HP Linear Scanner Quick Reference Guide2011 Hewlett-Packard Development Company, L.P About This Guide iv About This Guide Table of contents 1 Setting Up the Scanner2 Using the Scanner Appendix A TroubleshootingChemical Substances Restriction of Hazardous Substances RoHS1 Setting Up the Scanner 2 Chapter 1 Setting Up the Scanner 2 Using the Scanner Parts of the ScannerScanning Modes Trigger Single ModeTrigger Pulse Multiple Mode Trigger Hold Multiple ModeFlashing Mode Always On Stand ModeTrigger Object Sense Figure 2-6 Always OnProgramming Barcodes Resetting the Product Configuration to DefaultsUSB Interface LED and Beeper Indications IndicationA Troubleshooting Solving Common ProblemsOnline Technical Support Preparing to Call Technical SupportError messages received Hardware configuration Hardware and software you are usingB Agency Regulatory Notices Federal Communications Commission NoticeModifications CablesAvis Canadien Canadian NoticeEuropean Union Regulatory Notice Japanese Notice Korean Notice Product Environmental Notices Materials DisposalChemical Substances HP Recycling ProgramRestriction of Hazardous Substances RoHS SJ/T11363-2006  RoHS2003 2002/95/EC
Related manuals
Manual 2 pages 57.17 Kb