HP rp5800 Base Model Retail System, rp5800 Retail System manual Setting Up the Scanner

Page 7

1 Setting Up the Scanner

Follow the steps below to set up the scanner.

1.Connect the interface cable to the bottom of the scanner. Figure 1-1Connecting/Disconnecting the Cable

2.Connect the other end of the interface cable to a USB connector on the host device. Figure 1-2USB Interface Connection

3.Aim the scanner at the barcode and press the trigger. Figure 1-3Aiming and Scanning

ENWW

Image 7

Contents Quick Reference Guide HP Linear Scanner2011 Hewlett-Packard Development Company, L.P About This Guide iv About This Guide Appendix A Troubleshooting Table of contents1 Setting Up the Scanner 2 Using the ScannerRestriction of Hazardous Substances RoHS Chemical Substances1 Setting Up the Scanner 2 Chapter 1 Setting Up the Scanner Trigger Single Mode 2 Using the ScannerParts of the Scanner Scanning ModesTrigger Pulse Multiple Mode Trigger Hold Multiple ModeFlashing Mode Figure 2-6 Always On Always OnStand Mode Trigger Object SenseProgramming Barcodes Resetting the Product Configuration to DefaultsUSB Interface Indication LED and Beeper IndicationsPreparing to Call Technical Support A TroubleshootingSolving Common Problems Online Technical SupportHardware and software you are using Error messages received Hardware configurationCables B Agency Regulatory NoticesFederal Communications Commission Notice ModificationsAvis Canadien Canadian NoticeEuropean Union Regulatory Notice Materials Disposal Japanese Notice Korean Notice Product Environmental NoticesChemical Substances HP Recycling ProgramRestriction of Hazardous Substances RoHS 2002/95/EC SJ/T11363-2006 RoHS 2003

Related manuals

Manual 2 pages 57.17 Kb