5.Pull the drive straight forward approximately 3/4” to release the drive from the tab on the chassis, then lift up and out to remove the drive from the chassis.
Replacing a Removable Media Drive
To replace the removable DVD drive, perform the following steps:
1.If a removable media drive has not previously been installed in the server, the drive slot will be covered with a DVD drive filler. Remove the DVD drive filler.
2.Align the replacement drive over the tab on the chassis and lower the drive onto the tab. Slide the drive toward the rear approximately 3/4” until it stops sliding and the retaining clips on both sides of the drive snap into place.
3.Connect the IDE cable on the back of the drive.
4.Replace the cover.
5.Reconnect the power and external cables and turn on the system.
6.Verify that the replacement drive is operational.
•Run info io at the EFI shell to verify that the replacement drive has been properly installed.
Removing and Replacing the Optional Management Processor Card
The optional management processor is an independent support system for the server. It provides a way to connect to a server and perform administration or monitoring tasks for the server hardware.
Removing the Optional Management Processor Card
1.Turn off the system, disconnect all power and external cables and remove the system cover(s).
2.Record the network settings from your management processor card before beginning this task.
3.Unscrew the two mounting screws that connect the management processor card to the internal chassis post and the two external mounting screws that are located on both sides of the
4.Disconnect the management processor card connector.
5.Remove the management processor card from the system by grasping it by its edges.
6.Replace the management processor card blank, if available, on the chassis. This blank is used to fill the holes left by the 10/100 Management LAN,
7.Push the management processor card blank against the inside of the chassis and screw in the blank’s mounting screw on the external connector side of the system’s chassis.
8.Replace the cover(s) and reconnect the power and external cables.
Replacing the Optional Management Processor Card
1.Turn off the system, disconnect all power and external cables, and remove the system cover(s).
2.If you are replacing a card, remove the MP card.
3.Align the MP card over the two mounting posts on the system board and align the three connectors of the MP card with the cutouts on the rear panel.
4.Carefully push the 10/100 Management LAN,
CAUTION: Special care should be used when mating the connectors of the MP card with the sheet metal of the rear panel. It is possible to damage the EMI gasket of the
Removing and Replacing the Optional Management Processor Card 63