HP IQ504 KQ436AA-NOOS, 22 Inch KQ437AA, Debranded 22 Inch TSMT506 Setting up a wired home network

Setting up a wired home network

First-time wired network installation requires that you:

1Purchase high-speed Internet service from an Internet service provider (ISP).

2Purchase a broadband modem (DSL or cable). This may be provided by the ISP.

3Purchase and install a wired router (sold separately), if one is required.

NOTE: Broadband modem and router installation procedures vary, depending on the manufacturer. Follow the manufacturer’s instructions.

4Connect the DSL cable (shown) or coaxial cable (not shown) from the wall to the modem.

5Connect the modem to the computer Ethernet port with an Ethernet cable. If you want to connect multiple devices to the network, connect a router or hub (not shown) to the modem with an Ethernet cable, and then connect the computer to the router with an Ethernet cable.

If you have an actual wired network in your home with Ethernet connectors in the wall, connect directly from your computer Ethernet port to the Ethernet wall connector with an Ethernet cable.

The Ethernet port on the HP TouchSmart PC is located on the back of the computer, behind the connector cover. For clean cable management, route the cable through the cable router clip on the back of the PC (shown), then route the cable through the notch in the back stand (not shown), then close the back connector cover.

Wired router

Internet	Wall plug	Broadband
		modem
		(DSL/cable)

Configurations vary by model

Getting to Know the HP TouchSmart PC 15