HP Debranded 22 Inch TSMT506, 22 Inch KQ437AA Setting up the HP TouchSmart PC with a set-top box

Setting up the HP TouchSmart PC with a set-top box

Select models only

If your TV signal requires a cable TV set-top box, a satellite set-top box, or another set-top box, you must connect the IR emitter cable to the computer and your set-top box to use the remote control properly. TV tuners and remote controls are included in select models only.

The IR emitter cable is a remote control sensing device that connects to the computer and covers the remote sensor on a set-top box. It enables the remote control that came with your HP TouchSmart PC to operate your set-top box when you use the Windows Media Center program to select TV channels.

To use a set-top box with Windows Media Center:

1Connect the IR emitter cable (A) to the IR Out connector (D) on the back of the computer.

2Remove the paper from the backing tape on the end of the cable (B), and then press the end of the cable over the remote IR sensor (receiver) window on the set-top box (C). To locate the remote infrared sensor window, shine a flashlight through the plastic on the front of the set-top box.

3When you use the remote control, point it at the front of the HP TouchSmart PC (E), not at the set-top box.

C

A

D E

B

Completing the Windows Media Center setup wizard

Select models only

1Open Windows Media Center. Tap the Windows Vista start button , tap All Programs, and then tap Windows Media Center.

Or

To open Windows Media Center from HP TouchSmart, open HP TouchSmart, and tap the Windows Media Center tile.

2Scroll to the Tasks menu, and select settings, General, and then select Windows Media Center Setup.

3Follow the onscreen instructions to set up your TV tuner and Windows Media Center TV program guide.

For more information about setting up and using Windows Media Center, go to: http://www.microsoft.com

20Getting Started