6.Install guide screws on the sides of the drive. If you are installing a 2.5-inch drive, you must install the drive in an adapter bracket.
NOTE: The hard drive uses 6-32 isolation mounting guide screws. Four extra guide screws are installed on the exterior of the hard drive bays. The HP-supplied isolation mounting guide screws are silver and blue. Refer to Installing and Removing Drives on page 25 for an illustration of the extra 6-32 isolation mounting guide screws location.
If you are replacing a drive, transfer the guides screws from the old drive to the new one.
●If you are installing a 3.5-inch hard drive, install four isolation mounting guide screws (two on each side of the drive).
Figure 2-26Installing Isolation Mounting Guide Screws in a 3.5-inch Drive
●If you are installing a 2.5-inch hard drive:
◦Slide the drive into the bay adapter bracket, ensuring the connector on the drive is fully inserted into the connector on the adapter bracket.
Figure 2-27Sliding the 2.5-inch Drive in the Adapter Bracket
34 Chapter 2 Microtower (MT) Hardware Upgrades