Power connector cable
Description | Spare part number |
|
|
Power connector cable (includes cable and connector) | |
|
|
Before removing the power connector cable, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.
4.Remove the battery (see Battery on page 52).
5.Remove the following components:
a.Hard drive (see Hard drive on page 53)
b.Optical drive (see Optical drive on page 56)
c.Keyboard (see Keyboard on page 62)
d.Top cover (see Top cover on page 64))
Remove the power connector cable:
1.Turn the computer upright with the right side toward you.
2.Disconnect the power connector cable (1) from the system board.
3.Lift the power connector (2) from the clips built into the base enclosure.
4.Remove the cable from the base enclosure.
Reverse this procedure to install the power connector cable.
ENWW | Component replacement procedures 73 |