HP 80XL302 manual Suspend Data to, Cover Close, Battery Low Warning Beep, VGA Activity

CRT Display Suspend

Saving starts the time-out for the Suspend mode. If the notebook remains in Standby mode until the time-out period for Suspend mode has been reached, the notebook enters Suspend mode.

The Suspend mode is determined by the next item, “Suspend Data to.” It can be either Suspend-to-RAM or Suspend-to-File.

When Suspend-to-RAM mode is initiated, several system subsystems go into standby or off mode so that system power will be reduced further. The system will wake up from Suspend-to-RAM mode when a key is pressed. “Resume On Time” and “Resume On Modem Ring”, if enabled in this submenu, can also wake up the system from Suspend-to-RAM mode.

When Suspend-to-File mode is initiated, the system preserves all the running application programs as a file in a “suspend-to-file partition” on the hard disk and then turns off automatically.

The available options are Disabled, 1 Min, 2 Min, 5 Min, 10 Min, and 15 Min.

Suspend Data to

The “Suspend Data to” item defines the Suspend mode of your system.

The available options are RAM and Disk.

Cover Close

The “Cover Close” item sets the notebook status when you close the cover.

Descriptions of the available options are:

Options Descriptions

Video Off The LCD screen will be off when you close the cover.

The display output will switch to the external CRT monitor.

Either Suspend-to-RAM or Suspend-to-File is initiated depending on the setting of the previous item, “Suspend Data to”.

Battery Low Warning Beep

This item sets if the system will alert you upon low battery capacity.

The available options are Enabled and Disabled.

VGA Activity

The “VGA Activity” item sets if obvious video activities (such as screen savers) will prevent Power Management modes.

My Presario – Getting Started Setup Configuration Utility 5-9