HP EX Plus manual Verifying the Hardware Installation, Selecting a Configuration Page Language

Page 19

8.Plug the power module into the wall outlet . Since there is no power switch, the print server is switched on after you plug it in.

9.Check the LEDs on the front of print server. The Status LED should be green—either steady or blinking.

If the internal self-test failed, the Activity LED will be on and the Status LED will be off. For troubleshooting information, see the Troubleshooting chapter in the software guide shipped with your print server.

10.Wait about 10 seconds. For 10Base-T and 100Base-TX networks, check the 10 and 100 LEDs on the back to verify that the correct one is lit. See p.1-8.

11.Switch on the power on your printer(s) to begin printing.

Verifying the Hardware Installation

To verify the installation of the HP JetDirect external printer server, generate a configuration page. This page is generated from Port 1 of the printer server.

To generate a configuration page, follow these steps:

1.Print a configuration page by pressing and releasing the Test button on the print server.

2.If the configuration page displays the message I/O CARD READY, you have successfully completed the hardware installation.

Selecting a Configuration Page Language

The configuration page for the HP JetDirect external print server is sent to the printer attached to Port 1. The printer language is auto-detected the first time the print server is powered up and after each cold reset.

2 Hardware Installation

Hardware Installation 2-3

Image 19
Contents HP JetDirect External Print Servers Page Page Publication number November Applicable Products Contents Page Product Overview Supported Printers, Plotters, and HP All-in-One Peripherals 1Product Overview HP JetDirect 300X J3263A Components and FeaturesProduct Overview Transmission Media Hardware Requirements Status Activity LED is Then the print server is LEDsSwitches HP JetDirect 300X Product Overview Token Ring data-rate switch set at 16 Mpbs on the J3264A Hardware InstallationFollowing steps, the circled numbers Selecting a Configuration Page Language Verifying the Hardware InstallationResetting to Factory Defaults Physical Specifications SpecificationsSpecifications Power RequirementsSpecifications A-3 Electromagnetic Emissions EnvironmentalFCC Statement U.S.A Regulatory StatementsEuropean Community Declaration of Conformity Statements Chinese Safety Statement Page 5969-3466