Hardware Installation

To install the HP JetDirect external print servers, you need to complete these steps.

●Verify that your printer parallel port(s) work properly.

●Connect the print server to the network and printer(s) and plug in the print server.

●Generate a configuration page from the print server.

After you install the print server, the next step will be to configure it.

Follow these instructions to install the HP JetDirect external print servers. (“Printer” refers to any peripheral you are connecting to the print server.)

1.To ensure your printer(s) work properly, do one of the following:

■send data through the parallel port of each printer you are connecting to the print server, or

■generate a printer self-test page (refer to your printer manual for instructions).

2.Switch off the power for each printer.

3.For a Token Ring print server (J3264A), set the data-rate switch to the appropriate speed (4 Mbps or 16 Mbps) (Figure 2.1). To do this, take a pen or similar object and slide the switch up for 16 Mbps or down for 4 Mbps.

Data-rate switch

Figure 2.1 Token Ring data-rate switch set at 16 Mpbs on the J3264A

2-1