HP 3Com 3C905B D7523A, 3Com 3C905B D7522A manual Installing the Driver from the diskettes

HP 10/100 3Com 3C905C-TX Network Interface Card Installation Guide

Software Installation Procedure

You will need the following information from your MIS department:

•Whether you are on a LAN or are connecting to one through a modem

•The protocol used in the Microsoft Windows Network (typically TCP/IP or NetBEUI)

•The name of the Windows NT server domain or workgroup you belong to

•Your IP address if you are using TCP/IP without DHCP

Installing the Driver from the diskettes

To install the network driver in a PC running Windows NT version 4.0:

1Restart the PC and start Windows NT.

2Double-click on the My Computer icon, then double-click on the

Control Panel icon.

3In the Control Panel window, double-click on Network.

4When prompted to install Windows NT Networking, click on Yes. If you do not receive this prompt and the Network control panel window appears, Windows NT Networking is already installed.

You will need to add the adapter manually: click on the Adapter tab, then click on Add... and follow the instructions from step 7 onwards.

5In the Network Setup Wizard window, select Wired to the Network and click on Next.

6When prompted to start searching for a network adapter, click on

Select from List...

7In the Select Network Adapter window, click on Have Disk...

8Insert diskette 1 in your drive and type A:\ at the prompt, then press ENTER.

9In the OEM Option window, highlight 3Com EtherLink 10/100 PCI For Complete PC Management NIC (3C905C-TX) and click on OK, then click on Next. If you are in the Network control panel window, click on Close and follow the instructions from step 14 onwards.

10Select the Network Protocols that are used by your LAN and click on Next.

11Select the Network Services that should be used by your PC when connected to your LAN and click on Next.

12Click on Next to begin the software installation with the settings you have provided.

14 English