Pen holder and eject assembly
Description | Spare part number |
|
|
Pen holder and eject assembly | |
|
|
Before removing the pen holder and eject assembly, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power cord.
4.Remove the battery (see Battery on page 35).
5.Remove the following components:
a.Hard drive (see Hard drive on page 37).
b.Memory cover (see Memory module on page 40).
c.Top cover (see Top cover on page 48).
Remove the pen holder and eject assembly:
1.Remove the three Phillips PM2.0×4.0 screws (1) that secure the pen holder and eject assembly to the base enclosure.
2.Remove the pen holder (2) and eject assembly (3) from the base enclosure.
Reverse this procedure to install the pen holder and eject assembly.
52 Chapter 4 Removal and replacement procedures | ENWW |