4.Release the ZIF connector to which the Media Card reader assembly cable is attached, and then disconnect the Media Card reader assembly cable (3) from the Media Card reader assembly.
5.Remove the Media Card reader assembly.
Reverse this procedure to install the Media Card reader assembly.
RTC battery
Description | Spare part number |
|
|
RTC battery |
|
|
|
Before removing the RTC battery, follow these steps:
1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect the power from the computer by unplugging the power cord from the computer.
3.Disconnect all external devices from the computer.
4.Remove the battery (see Battery on page 45), and then remove the following components:
a.Service cover (see Service cover on page 47)
b.Hard drive (see Hard drive on page 48)
c.WLAN module (see WLAN module on page 51)
d.WWAN module (see WWAN module on page 53)
Component replacement procedures | 73 |