HP Dv6 6108Us manual

7.If you are replacing a memory module, remove the existing memory module:

a.Pull away the retention clips (1) on each side of the memory module. The memory module tilts up.

b.Grasp the edge of the memory module (2), and then gently pull the memory module out of the memory module slot.

CAUTION: To prevent damage to the memory module, hold the memory module by the edges only. Do not touch the components on the memory module.

To protect a memory module after removal, place it in an electrostatic-safe container.

8.Insert a new memory module:

CAUTION: To prevent damage to the memory module, hold the memory module by the edges only. Do not touch the components on the memory module.

a.Align the notched edge (1) of the memory module with the tab in the memory module slot.

b.With the memory module at a 45-degree angle from the surface of the memory module compartment, press the module (2) into the memory module slot until it is seated.

c.Gently press the memory module (3) down, applying pressure to both the left and right edges of the memory module, until the retention clips snap into place.

CAUTION: To prevent damage to the memory module, be sure that you do not bend the memory module.

36 Chapter 5 Maintenance