HP m7288a, a1260a Additional Safety Information, AC Power Safety Warning, Save These Instructions

Page 13
•For automatically initiated calls to the same number:

Some parameters required for compliance with Telecom’s Telepermit requirements are dependent on the equipment (PC) associated with this modem. The associated equipment shall be set to operate within the following limits for compliance with Telecom’s specification:

For automatically initiated calls to the same number:

(a) There shall be no more than 10 call attempts to the same number within any 30-minute period for a single manual call initiation.

and

(b) The equipment shall be on the hook for a period of not less than 30 seconds between the end of one attempt and the beginning of the next attempt.

For automatically initiated calls to different numbers: The equipment shall be on-hook for a period of not less than 5 seconds between the end of one attempt and the beginning of the next attempt.

For automatically answered incoming calls: Incoming calls shall be answered between 3 and 30 seconds of the first ring.

For correct operation of the ringers in each device, the total of the RNs (ringer number) of all devices connected to a single line at any time should not exceed 5. The RN can be found printed on the Telepermit Label.

WARNING: When using this device, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:

Do not use this product near water; for example, near a bathtub, wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool.

Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.

Do not use this product to report a gas leak in the vicinity of the leak.

Always disconnect the modem cable before opening the equipment enclosure or touching an uninsulated modem cable, jack, or internal components.

If this product was not provided with a telephone line cord, use only No. 26 AWG or larger telecommunication line cord in order to reduce the risk of fire.

Do not plug a modem or telephone cable into the Network Interface Card (NIC) receptacle.

SAVE THESE INSTRUCTIONS

Additional Safety Information

This product has not been evaluated for connection to an ”IT” power system (an AC distribution system with no direct connection to earth, according to IEC 60950).

AC Power Safety Warning

WARNING: Install the computer near an

AC outlet. The AC power cord is your PC’s main AC disconnecting device and must be easily accessible at all times. For your safety, the power cord provided with your PC has a grounded plug. Always use the power cord with a properly grounded wall outlet, to avoid the risk of electrical shock.

WARNING: Your PC is provided with a voltage select switch for use in a 115V￿ or 230V￿ power system. The voltage select switch has been pre-set to the correct voltage setting for use in the particular country/region where it was initially sold. Changing the voltage select switch to the incorrect position can damage your

PC and void any implied warranty.

WARNING: To reduce the possibility of an electric shock from the telephone network, plug your computer into the AC outlet before connecting

it to the telephone line. Also, disconnect the telephone line before unplugging your computer from the AC power outlet.

WARNING: Always disconnect the modem cord from the telephone system before installing or removing your computer cover.

WARNING: Do not operate the computer with the cover removed.

WARNING: For your safety, always unplug the PC from its power source and from any telecommunications systems (such as telephone lines), networks, or modems before performing any service procedures. Failure to do so may result in personal injury or equipment damage. Hazardous voltage levels are inside the power supply and modem of this product.

13

Image 13
Contents Product Name Model Number System or Product Number Serial Number Warranty and Support GuidePurchase Date Operating System Type and Revision Build-ID Number Press Ctrl-Alt-SWhere Are My User’s Guides? Where to Get HelpSoftware Support HP Support Web siteProblems? HP Will Help Warranty and License InformationTo Our Valued Customer See What You Can DoThe Legal Language Hardware Limited WarrantyGeneral Terms HP ProductExclusive Remedy ExclusionsLimitation of Liability Types of Warranty Service Limited Warranty PeriodOn-site Warranty Service Carry-in Warranty ServiceCustomer Self Repair Warranty Service Service UpgradesOptions and Software Limited Warranties TechSupport/Document.jsp?objectID=lpg50101Contacting HP Software Technical SupportEnd-User License Agreement 4. TRANSFER Rev. 10/03 DECLARATION OF CONFORMITY conforms to the following Product SpecificationsManufacturer’s Name Manufacturer’s AddressRegulatory and Safety Information Operating SpecificationsENERGY STAR Compliance Australia Telecom StatementAC Power Safety Warning Additional Safety InformationFor automatically initiated calls to the same number SAVE THESE INSTRUCTIONSLaser Safety Statement Lithium Battery CautionTV Antenna Connectors Protection Class 1 LED ProductPage Printed in
Related manuals
Manual 50 pages 41.56 Kb Manual 74 pages 57.44 Kb Manual 2 pages 20.36 Kb Manual 1 pages 48.4 Kb Manual 9 pages 38.43 Kb Manual 16 pages 53.11 Kb Manual 106 pages 60.13 Kb