HP a1260a manual Lithium Battery Caution, Laser Safety Statement, TV Antenna Connectors Protection

Page 14
Lithium Battery Caution

Lithium Battery Caution

WARNING: The PC uses a lithium battery, type CR2032. There is danger of an explosion if the battery is incorrectly replaced. Replace only with the same, or equivalent, type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instructions.

Lightning Protection

For added protection of any product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug the product from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product from lightning and power line surges.

Laser Safety Statement

Class 1 LED Product

The CD and DVD drives contain a laser system and are classified as a ”Class 1 Laser Product” under a

U.S. Department of Health and Human Services (DHHS) Radiation Performance standard according to the Radiation Control for Health and Safety Act of 1968.

Should the unit ever require maintenance, contact an authorized service location.

WARNING: Use of controls, adjustments, or performance procedures other than those specified in the Upgrading and Servicing Guide may result in hazardous radiation exposure.

1

Antenna Grounding

7

6

5

4

3

2

To prevent direct exposure to laser beam, do not try to open the enclosure of the CD or DVD drives.

Laser Product Label

The following label or equivalent is located on the surface of laser products:

This label indicates that the product is classified as a

CLASS 1 LASER PRODUCT. This label appears on a laser device installed in your product.

TV Antenna Connectors Protection

External Television Antenna Grounding

If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is electrically grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper electrical grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna-discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

Antenna Grounding

Reference

Grounding Component

1Electric Service Equipment

2

Power Service Grounding Electrode System

(NEC Art 250, Part H)

 

3Ground Clamps

4Grounding Conductors (NEC Section 810-21)

5Antenna Discharge Unit (NEC Section 810-20)

6Ground Clamp

7Antenna Lead in Wire

Power Lines

An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits.

WARNING: When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them could be fatal.

The information contained herein is subject to change without notice.

Copyright © 2004–2005 Hewlett-Packard Development Company, L.P.

14

Image 14
Contents Purchase Date Operating System Type and Revision Build-ID Number Warranty and Support GuideProduct Name Model Number System or Product Number Serial Number Press Ctrl-Alt-SSoftware Support Where to Get HelpWhere Are My User’s Guides? HP Support Web siteTo Our Valued Customer Warranty and License InformationProblems? HP Will Help See What You Can DoGeneral Terms Hardware Limited WarrantyThe Legal Language HP ProductLimitation of Liability ExclusionsExclusive Remedy On-site Warranty Service Limited Warranty PeriodTypes of Warranty Service Carry-in Warranty ServiceOptions and Software Limited Warranties Service UpgradesCustomer Self Repair Warranty Service TechSupport/Document.jsp?objectID=lpg50101End-User License Agreement Software Technical SupportContacting HP 4. TRANSFER Rev. 10/03 Manufacturer’s Name conforms to the following Product SpecificationsDECLARATION OF CONFORMITY Manufacturer’s AddressENERGY STAR Compliance Operating SpecificationsRegulatory and Safety Information Australia Telecom StatementFor automatically initiated calls to the same number Additional Safety InformationAC Power Safety Warning SAVE THESE INSTRUCTIONSTV Antenna Connectors Protection Lithium Battery CautionLaser Safety Statement Class 1 LED ProductPage Printed in
Related manuals
Manual 50 pages 41.56 Kb Manual 74 pages 57.44 Kb Manual 2 pages 20.36 Kb Manual 1 pages 48.4 Kb Manual 9 pages 38.43 Kb Manual 16 pages 53.11 Kb Manual 106 pages 60.13 Kb